Eaton ET9300-14-220 Instruction Manual - New Improved Eaton Method
A
E
D
B
C
New Improved Eaton Method
With the Eaton hydraulic hose saws
the hose is positioned across two
pins (A) and moved into the blade
(C) by a feed foot (B) using extend-
able handle (D) and adjustable pivot
point (E) for cutting larger indus-
trial hose. The feed motion causes
the hose to stretch at the point of
contact with the blade, allowing it to
separate as it is cut (see image at
below). This separation allows the
hose to pass clear of the saw blade
with NO friction, NO heating and
NO DEBRIS! A vacuum hose (not
shown) is attached to a vacuum port
to remove any tiny amount of debris
or smoke during cutting.
NO DEBRIS
1/8” Clean-Cuts Blade
Pin A
Pin A
Hose separates
as blade slices,
no kerf required.
EC230
EC230
Introduction
Eaton hydraulic hose cutting system is break-through technology using a toothed
knife, cutting with the backs of each tooth, so the knife does not take a kerf. The saw
bends the hose into the blade spreading the cut edges to avoid burning and smoking.
Old Method
The normal sawing method of lowering an abrasive
saw blade onto the hose causes the hose to com-
press and deform. As the blade cuts the compressed
hosed expands against the blade causing friction,
heating and burning and much of the debris from the
kerf of the blade is deposited into your hose.
DEBRIS INSIDE
YOUR HOSE!
1/8” Abrasive
Wheel
Hydraulic Hose
EC230
EC230
3