Eaton HOMECT Installation And Setup Manual - Home Automation Hub
Home Automation Hub
Quick-Start Guide
Support
For technical issues and additional support, please
contact Eaton Care at: techsupport@eaton.com or by
phone (866) 853-4293
For more information visit:
www.eaton.com/wiringdevices
Warranty Information
Eaton offers a two (2) year limited warranty on original
Eaton Home Automation Hub components, from the date
of shipment from Eaton. To view complete limited
warranty details, including limitations and exclusions,
visit www.eaton.com/wiringdevices. Scan the code
above to view product warranty details.
Additional Information and Support
Installation and Setup Guide:
Scan code to view the installation &
setup guide for more information.
(1) Recessed push button (4) Wall mount slot
(2) 2 USB ports
(5) Micro USB port
(3) Wire routing channel
(6) Ethernet port
LED Display
Troubleshooting
Solid Blue
Everything is working correctly.
Blinking Red
in 2 second
intervals
The controller is not connected to your
home network. Shutdown and power
cycle the controller.
Solid Red
ControllerOS is not operational. Shut
down and power cycle the controller.
Not Lit
There is no power connected to the
controller. Check that the power supplies
are plugged in and wired correctly.
When the controller reboots, it can take up to 25
seconds to successfully restart in *AP mode.
To shut down the controller, use the provided paper
clip to press and hold the recessed push
button down for 5 seconds.
To shut down controller and
power cycle in AP mode, use
the provided paper clip to
press and hold the recessed
button down for 20 seconds.
*AP mode: when the controller
is broadcasting local wi-fi
for installation purposes.
LED Indicators
Troubleshooting
Product Details
(1)
(5)
(6)
(4)
(3)
(2)
Eaton
Peachtree City, GA 30269
866-853-4293