Eaton i-on Compact User Manual - Wide Range of User Options
Page 5
You have the ability to enable or disable
remote access as required through the
User menu.
Wide range of user options
Authorised users can access a User menu
from the control unit. The menu contains
options to add users, omit zones, view log
information, test the system, configure the
system and switch devices (outputs) on or
off.
You can find full details of the user options
in the i-on Compact Administration and
User Manual.
Ability to omit zones
You can omit a zone before setting the
system (see page 7). Omitting a zone
temporarily excludes it from setting.
You may want to omit a zone to prevent
false alarms if, for example, the area
it protects is going to be temporarily
occupied while the rest of the system is
set.
Full logging
The control unit logs all actions, alarms
and alerts. You can review the logged
events through the User menu.
Jamming and tamper monitoring
i-on Compact uses advanced techniques
to monitor your system continuously for
possible jamming or tamper attacks.
Comprehensive test options
The User menu contains a comprehensive
set of options that you can use to test the
system or to determine the owner of a
device such as a proximity tag or remote
control.
Using i-on Compact
This section describes typical tasks that
you may need to carry out from time to
time once the system is set up.
Note: For further information about these
and other tasks, please refer to the i-on
Compact Administration and User Manual.
Control unit keypad
Figure 2. Control unit keypad
The keys have the following functions:
Navigation key:
Scrolls up, or moves the
cursor left.
Scrolls down, or moves the
cursor right.
Changes the value, displays
further information, or inserts
a space.
Changes the value, or
deletes the character to the
left.
The key glows red or green to
indicate system status (green
= normal; red = alarm/fault).
This key exits an option or
cancels a change.
Confirms an action, such
as selection of an option or
acknowledgement of an alarm.
Pressing this key gives you
access to the user menu
when the standby screen is
displayed (see page 7).