Eaton XP-503 User Manual - page 4
iv
Introduction
Windows Standard Embedded 7 User’s Guide for Eaton XP-503 with Visual Designer
MN031001EN August 2014 www.eaton.com
Introduction
The Eaton XP-503 family is made up of high performance
yet cost-effective, wide-screen, multi-touch operator
interface (OI) products. The XP-503 family carries on Eaton’s
operator interface tradition of high performance balanced
with ease of use. The XP-503 family sets the standard for
hybrid OI systems by combining the flexibility of Microsoft
Windows
Standard Embedded 7 operating system with
the stability and reliability achieved through a solid-state
hardware design and Eaton’s exclusive Protect Mode
feature that provides protection for unwanted changes to
the operating system and software.
The XP-503 family provides the performance and flexibility
of PC-based operator interfaces without the associated
complexity and maintenance of a PC on the plant floor.
With integrated high-speed Ethernet ports, serial ports,
USB ports, DVI-output, and removable C-Fast solid-state
memory, the XP-503 models can be adapted for a wide
variety of user requirements.
The XP-503 family of products configured with the Visual
Designer
software provides a range of solutions from
basic operator monitor and control functions to full SCADA
software capabilities with built-in Web Serving.
Whether replacing hard-wired pilot devices and pushbuttons
or providing machine control and high-end SCADA functions,
the XP-503 will suit a wide range of user requirements.
The remainder of this document describes some of the
operating system features of the XP-503 system.
10.10 Inches
15.60 Inches
21.50 Inches
www.comoso.com