EAW DX1208 Instruction Manual - page 11

DX1208 – 

11

6.  The DX Navigator Setup Wizard will begin installing the 

software on your computer’s hard drive.

Note:

 The following screenshots were taken on a computer 

running Windows Vista. If you are using an earlier version 

of Windows, the screens may appear slightly different.

7.  Click “Next” and read the License Agreement. Click “I 

Agree” to continue.

8.  A warning about removing previous versions of DX 

Navigator appears. Click “Next” to continue.

9.  You can accept the default directory, or specify a different 

location to install the application. Click “Next” to continue.

10. Wait a few moments while DX Navigator is installed on 

the computer. The following window will appear when the 

installation is complete. Leave the “Run DX Navigator” tick 

box checked. Click “Finish” to complete the installation of 

DX Navigator.

11. When DX Navigator opens, the following dialog box 

appears, informing you where the drivers are located on 

the hard drive (Program Files\EAW\Data\FTDI). Click “OK” to 

continue.