EAW KF860 Tech Note

EASTERN ACOUSTIC WORKS

One Main Street, Whitinsville, MA 01588 • (508) 234 - 6158 • FAX (508) 234 - 8251 • Email info@eaw.com • Web http://www.eaw.com

EAW products are continually improved. All specifications are therefore subject to change without notice. • PUB# KF860 Tech Notes 999274 (A)/4p/12/28/97 • Printed In USA

PROCEDURE

1

Hang the Flybar on an appropriate and properly

installed chain motor or hoist. Always use a licensed

rigger to install the chain motor.

SAFETY 

PINS

ADJUSTABLE 

RIGGING PLATE

FLYBAR

PLUNGER

BALL STOP

2

Install Rigging Plates (angled edge forward) into the

slots on each end of the Flybar. Align each Plate’s

top front and  3rd-from-the-top rear holes with the

holes in the Flybar as shown. Fully insert two Safety

Pins per Rigging Plate. Position both Rigging Plates

an equal distance from the front of the Flybar. The

tilt angle of the array can be adjusted by positioning

the first Module forward or back on the Flybar.

To insert a Safety Pin into a hole, depress its rear

plunger so that the two Ball Stops will recess into

the pin body. Once it is fully inserted into the

Module’s End Bracket release the rear plunger, and

the ball stops will lock the Safety Pin into place. A

fully inserted Safety Pins will pass through the

Flybar/End Bracket’s outer rail, the Rigging Plate and

the Flybar/End Bracket’s inner rail.

LOAD RATING

Safe working load is 4000 lb./Module.

Calculated at 5:1 safety factor + pull tested.

Maximum column length is 10 Modules.

RIGGING HARDWARE TECH NOTE

KF860

AC

O

US

TIC

AL

PER

FORMANCE PA

RTN

ER

SH

IP