EAW KF860 Tech Note - Rigging Hardware Tech Note
Acoustic Performance Partnership
Eastern Acoustic Works
KF860 Rigging Hardware Tech Note
One Main Street, Whitinsville MA, 01588 USA • Phone 508/234-6158 • Toll Free 800/992-5013 • Fax 508/234-8251 • Web http://www.eaw.com • email info@eaw.com
RIGGING HARDWARE TECH NOTE
KF860
AC
O
US
TIC
AL
PER
FORMANCE PA
RTN
ER
SH
IP
CASTER PALLET LATCH
ACCESS HOLE
(ONE EACH END)
7
Remove the Cart’s Flyclip from the back
of the Module.
8
Raise the Flybar and Module a few
inches so when you disconnect the
Caster Pallet it will drop an inch or so
onto the Cart.
9
Two latches, one on each end Module,
hold the Caster Pallet in place. Insert
the Allen Wrench into the latch hole
and turn counterclockwise, freeing the
Pallet. Remove the loose Pallet and
wheel away the Cart.
0
°
10
°
25
°
5
°
20
°
15
°
10
Raise the Array so the Module’s Bottom End Bracket is chest high. At this time, select the angle at which the next
Module is to be hung. The faces of any two adjacent Modules can be arrayed at 0
°
, 5
°
, 10
°
, 15
°
, 20
°
or 25
°
. Each
Rigging Plate offers eight holes (4 sets of two). Each Module’s Bottom End Bracket offers six holes (three sets of
two). Angles are determined by aligning the proper Rigging Plate holes with the proper Bottom End Bracket holes
(see diagrams). Install Rigging Plates into both ends of the Module.