Eberle Design Auxiliary Display Unit Operation Manual - page 8
Auxiliary Display Unit (ADU)
Operations Manual
Eberle Design Inc.
Page 5
3.2.1 STATUS
Pressing the SELECT button from the top level provides further details regarding the
current state including Field Check status (if applicable), Recurrent Pulse Status (if
applicable), Field Voltages, and Cabinet Voltages. This status may be current (no fault
state) or the latched status at the time of the fault (fault state).
3.2.2 MENU
Pressing the NEXT button followed by the SELECT button from the top level provides the
main Menu structure for selecting the following functions:
3.2.2.1 VIEW LOGS
This menu category provides a review of:
Previous Failure (PF) log
AC Line (AC) event log
Monitor Reset (MR) log
Events are stored with #1 being the newest event in the log. Pressing the NEXT button will
display the events from newest to oldest (#1 … #n). Pressing the BACK button will display
the events from oldest to newest (#n … #1).
The Diagnostic Wizard is automatically invoked when the HELP button is pressed while
reviewing any of the Previous Failure (PF) logs.
3.2.2.2 VIEW CONFIGURATION
This menu category provides a means to review and/or set configuration parameters that
are programmed into the Data Key. Note that to change a programming parameter, the
Data Key must be reprogrammed. Refer to the Eberle Design MonitorKey
®
Data Key
Programming Tool Operations Manual (pn 888-1212-001).
3.2.2.3 CLEAR LOGS
This menu category provides a means to clear the following logs:
Previous Failure (PF) log
AC Line (AC) event log
Monitor Reset (MR) log
Configuration (CF) log
The ALL selection will clear all four event logs.
3.2.2.4 VIEW FIRMWARE LEVEL
This menu item provides the CMU-212 monitor firmware level.
The Auxiliary Display Unit firmware level can be obtained by operating the Auxiliary Display
Unit without an SB#3 connection to the CMU-212 monitor. When SB#3 communications is
not operating, the Auxiliary Display Unit will default to a screen on the Main Status Display
the shows the installed firmware level.