Eberspächer 22 1543 89 00 00 Installation Instructions
J. Eberspächer
GmbH & Co. KG
Eberspächerstr. 24
D-73730 Esslingen
Telephone (switchboard)
(0711) 939-00
Facsimile
(0711) 939-0500
www.eberspaecher.com
USB adapter
22 1543 89 00 03 05.2011 Subject to change Printed in Germany © J. Eberspächer GmbH & Co. KG
Installation instructions
The USB adapter is used to connect EDiTH-Expert or EDiTH-
Basic to a PC without serial port.
USB adapter Order No. 22 1543 89 00 00
Scope of supply
1 USB adapter
1 CD with EDiTH software
1 Installation instructions
Supported operating systems
Windows 98; Windows Me; Windows 2000; Windows XP;
Windows Vista; Windows 7
System requirements
Before installing the EDiTH software, read the PDF document
»Operating Instructions for EDiTH Diagnostic Tool« contained
in the »Info« directory on the CD.
Installing the software
Start the »EDiTH-Setup.exe« file on the installation CD.
Follow the instructions on the screen.
Use with EDiTH-Basic
Please note!
• Do not disconnect the plug-in connection heater cable
loom / control cable loom (1) until the heater has been
switched off and the after-run has ended.
• It is important to always follow the precise connection order.
• Do not connect the USB adapter to the PC until the EDiTH
software has been installed on the computer.
• TheUSBadapterdoesnotworkunderWindowsNT.
Connect EDiTH-Basic
1. Start computer and wait until the system has successfully
booted.
2. Start EDiTH software.
3. Disconnect the connector in the heater cable loom / con-
trol cable loom (1).
4. Connect the adapter cable (2) to the heater cable loom /
control cable loom (1).
5. Connect the adapter cable (2) with the 6-pin connector
housing (3) of the connection cable (4).
6. Connect connection cable (4) at the EDiTH-Basic (A).
7. Connect EDiTH-Basic (A) with SUB-D connection cable (5)
and USB adapter (E) to the PC.
8. Start the diagnosis of the heater.
For a description of the heater diagnosis, see EDiTH Help.