Eberspächer AIRTRONIC D2 Installation Manual - page 9
Introduction
8
1
Planning your installation
9
2
Before you begin, we advise that you take some time to
plan the installation.
Where and how you install your system will depend
on various limitations of both your boat design and
construction as well as the technical specification of the
heater. Because of this we have endeavoured to give
helpful advice within the different sections of this manual,
so we advise that each section is read fully before
commencing the installation.
As a general guide before you begin, be aware of the
location of the boat’s fuel and water tanks, the batteries
and any cold box, fridge or cooker that may prohibit the
routing of the hot air ducting or affect the installation.
Before installing the heater into the boat, ensure that in
doing so you are not infringing upon, or contravening any
legal requirements of the boat’s use or construction. For
instance, if the boat is to be used for hire purposes, it
may require additional systems or warning labels to be
installed, which may not be mentioned in this manual.
Similarly, advice from the boat manufacturer may be
required if you plan to cut through bulkheads that may be
structurally important to the boat design.
Regulations that could affect the installation of the heater
may be different in each country/region, so please check.