Eberspächer EasyStart Remote Operating Instructions Manual - page 10
10 | VEHICLE HEATERS – TECHNICAL DOCUMENTATION
3 OPERATION AND SETTING/ADJUSTMENT
PERMANENTLY CHANGE THE OPERATING TIME
Keep the
button pressed until “CURRENT
OPERATING TIME WILL BE DISPLAYED AS
FLASHING” appears.
PLEASE NOTE!
A switched on heater is switched off with this
setting.
Data transmission
LED: lights up green
LED: flashes red for
8 seconds
Data transmission
LED: lights up green
Current operating
time is indicated
by flashing, e.g. 3x
red for 30 minutes
operating time.
Release the
button; further flashing sig-
nals follow for the selection of the operating
time (
see page 11
).
QUERY THE OPERATING STATE OF THE
HEATER
Press the
button, the connection is set up
with the stationary unit is.
Data transmission
LED: lights up green
The following indications are possible:
if the heater is ON
LED: flashes 5x
green
if the heater is OFF heater is switched on
LED: flashes 12x
green
If heating mode or ventilation mode is not
required, press the
button; the heater is
switched off.
PLEASE NOTE!
Possible LED indications such as alternat-
ing red-green flashing, red flashing or con-
tinuously lit red are described in the chapter
“What to do if …?”
from page 15
.