Eberspächer HYDRONIC B4WSC Technical manual - page 2
2
D
S
GB
F
Control elements, optional
Quantity / Designation
Order No.
1
Mini-clock – 12 / 24 volt
22 1000 31 31 00
The mini-clock can be combined
with the TP41i radio remote control.
1
Module clock – 12 / 24 volt
22 1000 30 34 00
The module clock can be combined
with the TP4i radio remote control.
1
Mounting parts for the
25 1482 70 01 00
module clock – only required
when installed with a shade
1
Change-over switch
22 1000 31 89 00
‘heating / ventilating’ 12 / 24 volt
Can only be used in combination
with a control element.
1
Remote radio control TP5
22 1000 32 01 00
The bi-directional remote radio control TP5 can be
used on its own for remote control of the heating
in the vehicle.
1
TP4i radio remote control
22 1000 30 99 00
12 / 24 volt
The TP4i radio remote control can only be used
in combination with the module clock.
1
TP41i radio remote control
22 1000 31 39 00
12 / 24 volt
The TP41i radio remote control can be used
on its own or in combination with the mini-clock.
Items supplied
Quantity / Designation
Order No.
1
HYDRONIC B 4 W SC – 12 volt 20 1824 05 00 00
To be additionally ordered:
1 Universal mounting kit
20 1824 80 00 00
or
1
HYDRONIC B 4 W SC – 12 volt 20 1821 05 00 00
As a complete package*
1
HYDRONIC B 5 W SC – 12 volt 20 1820 05 00 00
To be additionally ordered:
1 Universal mounting kit
20 1820 80 00 00
or
1
HYDRONIC B 5 W SC – 12 volt 20 1823 05 00 00
As a complete package*
* The complete package consists of:
1 Heater
1 Universal mounting kit
Optional extras
1 Check valve, Ø 18 mm
254 00 070
1 Check valve, Ø 20 mm
254 00 074
1 Comfort mounting kit (B 5 W SC only) for engines
from 2.5 l cubic capacity
24 0132 00 00 00
The comfort mounting kit includes the following:
1 thermostat, Ø 18 mm
1 T-piece, Ø 18 mm
1 check valve, Ø 18 mm
1 water hose, Ø 18 mm
10 hose clamps
Please refer to the Extra Parts Catalogue for other
additional parts.
ATTENTION!
Before switching on or preprogramming the heating, put
the vehicle’s heating lever (provided the vehicle is
equipped with one) to “HOT” (maximum position) and
the fan to “slowest speed” (low current consumption).
For vehicles with automatic heating, put the heating
lever to “MAX.” and the desired damper position to
“OPEN” before switching off the ignition.
Please note!
Control elements must be selected in accordance
with the intended use of the
HYDRONIC and on the
basis of the distinction: air or water heater, simple
switching on and off, programme preselection and /
or radio remote control. The control elements are
supplied with operating instructions. These are
intended to be handed over to the customer
together with the mounting and operating
instructions for the
HYDRONIC.