EBS Fafner II-XD EXTREME EDITION User Manual - page 7
REAR PANEL CONNECTIONS AND CONTROLS
FUNCTIONAL DESCRIPTION
10
7
13
14
15
16
VOLUME
BALANCED OUTPUTS
STANDBY
- The VOLUME knob controls all
volume in the unit, controlling the poweramp
and LINE output. The balanced outputs (XLR)
are not affected by the setting of this knob.
- A balanced output
functions as a high quality line box for
connecting to PA mixing consoles or to studio or
broadcast recording units, with high noise
immunity.
The EBS Fafner is equipped with two balanced
outputs, in order to be able to monitor both the
input signal and the signal from the entire
preamp.
The
output is a direct copy of the
signal present at the input jack, so no controls
effect this output.
The
outputs the signal after the entire
preamp and is not dependent of the output
volume.
Lifting ground is a great aid in many occasions.
When required, set the
switch at the
front panel to inner position to disconnect the
ground from the outputs.
The
switch sets the option of either studio
standard leve, in outer position, or when pressed
microphone level.
- This switch disconnects the
poweramp from the speaker outputs, mutes the
line output and the balanced outputs. The mute
function can also be remotely controlled.
PRE EQ
POST EQ
Gnd Lift
Pad
Please
refer to the rear panel description of the remote
jacks.
- Switches the amp on or off.
POWER
1
9
7
10
1
5
6
7
2
3
4
11
2
3
4
6
8
5
F
UNCTIONAL
D
ESCRIPTION
R
EAR
P
ANEL
:
POST LOOP
CLEAN CHANNEL LOOP
DRIVE CHANNEL LOOP
EFFECTS LOOP
- This serial loop is situated after
the VOLUME control. Use the
for
connecting to another poweramp or to another
Fafners
for connecting
two amps together.
- This is the clean
channel serial loop and is only active for the
clean channel.
- This is the drive
channel serial loop and is only active for the
drive channel.
- This is the common effects
loop available for both channels and is situated
after the individual channel loops.
LINE OUT
POWERAMP INPUT
FX MIX
LO-Z INPUT
TUNER OUT
– This control controls the mix level
for the common
, from 0%
(off) to 50% (parallel), to 100% (serial).
– This input is a low impedance
input suitable for connecting wireless systems or
other sources without the need of using the input
on the front panel. When connecting to the input
on the front panel, this input is disabled.
- This low impedance output is
suitable for driving tuners. The signal from this
output is identical to the instruments' signal.
EFFECTS LOOP
FAFNER XD MANUAL