Eccotemp EM-2.5 Use And Care Manual - Technical Description
7
Product Support: Eccotemp.com/help-desk Shop Online: Eccotemp.com/products Store Locator: Eccotemp.com/locator
Phone: 866-356-1992 | Email: Support@eccotemp.com | Address: 315 - A Industrial RD Summerville, SC 29483
TECHNICAl DESCRIPTION
There are three Seisco Mini tank models, a 2.5-gallon, a 4-gallon and a
6-gallon model. The pressure vessel (water tank) is welded, glass lined
steel and is equipped with an anode rod.
The water heater is equipped with a thermostat and a high limit
temperature switch. A temperature/pressure relief valve is supplied with
the unit.
INSTALLATION INSTRUCTIONS
MODELS: EM2.S - EM4 - EM6
A licensed professional must complete the installation adhering to all
state and local codes. The manufacturer will not be liable for any
damages because of failure to comply with these installation instructions
or because of improper installation performed by an unqualified installer.
CHOOSE A LOCATION that allows ease of access for maintenance
ideally with at least 9 clearance at the top from the ceiling, cabinet, or
any adjacent walls.
WALL MOUNTING
Fasten the supplied mounting bracket to the wall. Use screws that are
suitable for the wall material and the weight of the water heater filled to
capacity (EM2.5-41 lbs.; EM4-57 lbs.; EM6-76 lbs.). Hang the water
heater on the bracket and pull downwards on the water heater to ensure
that both ~ingers?of the bracket are seated in the mounting slots.
Confirm your water piping orientation (hot and cold) before wall
mounting. ONLY INSTALL IN VERTICAL POSITION.
Heater can also sit on the floor. ONLY INSTALL IN VERTICAL
POSITION! EM models can be installed under the sink.