Eccotemp iE-11 Quick Start Manual - page 11

Phone: 866-356-1992 | Email: Support@eccotemp.com | Address: 315 - A Industrial RD Summerville, SC 29483

PLEASE NOTE: THIS MANUAL IS SUBJECT TO CHANGE AT ANYTIME, TO ENSURE THIS MANUAL IS UP TO DATE PLEASE VISIT OUR HELP DESK

AT WWW.ECCOTEMP.COM FOR ALL OF OUR PRODUCT MANUALS.

7

Product Support: Eccotemp.com/help-desk            Shop Online: Eccotemp.com/products          Store Locater: Eccotemp.com/locater

INSTALLATION LOCATION & METHOD

Fixed installation on the wall

Locate an appropriate place on a section of wall that meets all safety and installation requirements 

Fig 1

Front and back of the appliance

Fig 2

Remove screw which fixed the bracket on back of the appliance.

Fig 3

                  Hold the back bracket hanger in position against the wall in the desired hanging location. Check to 

make sure that the bracket is level. Mark the wall where the mounting holes should be located. Drill holes of 1/4” 

diameter in the marked locations. If you are on a stud, screw the bracket directly into the wall. If you are not on a 

stud, insert the plastic anchor in the hole, and secure the bracket using the screwing supplied.

1.2 in.

17

.8 in.

2.5 in.

1.2 in.

2.5 in.