Eccotemp L10 User Manual - Use And Starting
12
Before going to the USE section:
Check around area for flammables, especially
gasoline or other vapors which may ignite. The
exhaust and top of the unit will get HOT! Make sure
there are no foreign objects around the unit or have
fallen into the top.
Use and Starting
1. Turn on incoming water supply. Ensure that you have
adequate water pressure of between 40-50PSI.
2. Turn your water output device to its “off” position.
3. Turn the gas valve on the cylinder all the way open.
4. IF THE SMELL OF GAS IS DETECTED, TURN OFF THE
GAS VALVE IMMEDIATELY!!!!
5. Set the water regulator knob on the face of the unit to
its highest setting.
6. Set the gas regulator knob on the face of the unit to
its minimum setting.
7. Turn on your water output device to the “on” position
and adjust to the desired water flow.
8. There will be a series of audible clicks and the burner
will ignite. (Should the burner not ignite after 5
seconds, shut off and go to the “Trouble Shooting”
section.
13
9. Upon completion of use or storage, open the drain
valve (ribbed cylindrical stem next to the water input
valve) to ensure draining of water.
10. WARNING: If the outside temperature is around or
below freezing (32 degrees F, 0 degrees C), ensure
that the drain valve is opened and water drained from
the unit after each use to avoid internal damage to the
water regulator. You will also need to unhook the
outgoing water line to ensure that any water in the
heat exchanger is drained. Failure to properly drain
your unit will cause water damage which may or may
not be reparable. Please check the warranty
information
found
on
our
website
at
www.eccotemp.com/freeze.htm
for more information
on freezing issues.