Echelon Excel 50 Installation Instructions Manual - Revision Overview
EXCEL 50 INSTALLATION INSTRUCTIONS
5
EN1B-0101
REVISION OVERVIEW
On the following pages changes have been made compared to the previous release of this document:
Page:
Change:
13
Added section "Lightning Protection"
Pull-up resistor disabled.
14, 15
Changed Fig. 24, Fig. 25, and Fig. 26
16
NO/NC attribute.
23
Added XD52-FC and XD52FCS.
28
Added Reset Modem available in System Info sequence, added note ISDN for Europe, only.
29
Added “Europe, only” for GSM, added comment about separate telephone numbers for voice and data.
33
Added alternate way to verify signal quality, new note about PUK, new step 15.
35
New Start-up Sequence.
29
Added section "TCP/IP Dial-Up via TCP/IP Modem XM500"
GENERAL
Safety Instructions
• When performing any work (installation, mounting,
start-up), all instructions given by the manufacturer and
in particular the safety instructions provided in the In-
stallation Instructions are to be observed.
• The Excel 50 Controller may be installed and mounted
only by authorized and trained personnel.
• If the unit is modified in any way, except by the manu-
facturer, all warranties concerning operation and safety
are invalidated.
• Make sure that certain local standards and regulations
are observed at all times. Examples of such regulations
are VDE 0800 and VDE 0100.
• Use only accessory equipment that comes from or has
been approved by Honeywell.
• Before the system is dismantled, disconnect the power
supply. Do this by removing the terminal block or by in-
stalling an additional 3
rd
-party switch onto the DIN-rail
close to the controller; see the following caution and
note.
CAUTION
Disconnect the power supply before you start to in-
stall the Excel 50 Controller. Do not reconnect the
power supply until you have completed installation.
IMPORTANT
To comply with CE requirements, devices with a
voltage in the range of 50 to 1000 Vac or 75 to
1500 Vdc which are not provided with a supply
cord and a plug or with other means for discon-
nection from the supply having a contact
separation of at least 3 mm in all poles, must have
the means for disconnection incorporated in the
fixed wiring.
CAUTION
Disconnect the power supply before removing or
plugging in the application module.