Echo CS-355T Instruction Manual - Preparation For Use

10

CS-361P

PREPARATION FOR USE

Clutch cover

Brake lever

(Front hand guard)

Two nuts

Unlock chain brake

   WARNING

Saw chain is sharp! Always wear gloves 

when handling assembly, otherwise serious 

personal injury may result.

KICK GUARD

®

 TO BAR  

INSTRUCTIONS

Tools Needed: Two 3/8 in. or 11 mm (7/16 in.) 

Wrenches.

For saws with Kick Guard

®

 P/N 2894902 and 

Symmetrical Low-Kick type guide bars.

1a. Install 8-32 bolt in 

small hole of Kick Guard

®

and through 

small hole in guide bar.

1b. Install 1/4-27 bolt in 

large rear hole of Kick 

Guard

®

 and through 

large front hole in guide 

bar.

2. 

IMPORTANT: Dimple in Kick Guard

®

 (A) 

must 

engage recess in guide bar (B).

3.  Tighten nut (C) and bolt by hand until snug. 

Make certain Kick Guard

®

 is flush against guide 

bar.

4.  Tighten nut additional 1/2 turn.

5.  Check to make certain Kick Guard

®

 is tight on 

guide bar.

GUIDE BAR AND SAW CHAIN  

INSTALLATION/REMOVAL

NOTICE

•Movethechainbrakelever(Fronthandguard)

fully rearward to remove or install the clutch 

cover to chain saw.

1. Remove spark plug lead. 

2. Remove the clutch cover nuts and remove clutch 

cover.

3. Remove bar and saw chain if necessary. See 

“Maintenance and Care” section for guide bar/

saw chain maintenance procedures.

1a.

1b.