Echo EDR-260 Operator's Manual - Starting Cold Engine
8
IMPORTANT
Stored fuel ages. Do not mix more fuel than
you expect to use in thirty (30) days, ninety
(90) days when a fuel stabilizer is added.
Stored two-stroke fuel may separate.
ALWAYS shake fuel container thoroughly
before each use.
ON
STOP
Throttle trigger
STARTING COLD ENGINE
Choke lever
Starter handle
Throttle trigger lockout
Fuel return line
Purge bulb
Push
(Open)
RUN
START
(Close)
Ignition switch
WARNING DANGER
• WHEN ENGINE IS STARTED, CONFIRM IF
THERE IS NOT ANY ABNORMAL
VIBRATION OR SOUND. IF THERE IS
ABNORMAL VIBRATION OR SOUND, ASK
YOUR DEALER TO REPAIR.
• AFTER REFUELING, TIGHTEN FUEL CAP
FIRMLY AND CHECK FOR LEAKAGE. IN
CASE OF FUEL LEAKAGE, REPAIR
BEFORE STARTING OPERATION SINCE
THERE IS A DANGER OF FIRE.
•
It is not permitted to fill fuel above the shoulder
level of fuel tank.
•
Stand the engine upright on a level surface.
•
Place ignition switch in ON (START/RUN)
position.
•
Push purge bulb 3 to 4 times (or until fuel is
visible in fuel return line).
•
Shift choke lever to close position (START).
•
Pull starter handle until the engine fires.
•
Shift choke lever to full open position, and if
necessary, start the engine again and allow to
warm up before using.
- The clutch engages at approximately 3,500
r/min. Therefore the drill bit may rotate at fast
idle engine speed.
Shoulder level
Fuel tank