Echo GINA 3G Owner's Manual - page 7
Connecting to the Audio Interface
11
Connecting to the Audio Interface
The Layla3G and Gina3G audio interfaces contain a wide variety of connections
that allow great flexibility in operation. For optimal performance, it is critical to
use the appropriate cabling and connectors.
Analog Inputs and Outputs – Layla3G
Layla3G’s front panel has two universal inputs (#s 1 – 2) with meters and trim
knobs, a phantom power switch and light (+48v), and an amber power indicator
light. There is also a ¼” headphone output jack, with a corresponding volume
knob, which monitors analog outputs 1 and 2.
Layla3G has six analog line inputs (#s 3 – 8) and eight analog line outputs on the
rear panel. These analog inputs (#s 3 – 8) operate with an input impedance of
10Kohms. The input and output connections can be used with balanced or
unbalanced cables via the ¼” connectors. By default, the inputs and outputs are set
to receive or send a +4dBu signal. You can switch between +4dBu and –10dBV
for each individual input and output via the console software (see section below).
There are also two channel inserts on the rear panel where you can connect a serial
effects device (compressor, EQ, etc.) for the universal inputs (#s 1 – 2).
Connecting to the Audio Interface