1. DL manuals
  2. Echo
  3. Trimmer
  4. HC-150
  5. Operator's Manual

Echo HC-150 Operator's Manual

Other manuals for HC-150: Operator's Manual, Operator's Manual
Manual is about: Hedge Clipper

Summary of HC-150

  • Page 1

    Hedge clipper operator's manual model hc-150 x7532247005 x753002865 12/11 warning users of this equipment risk injury to themselves and others if the unit is used im- properly and/or safety precautions are not followed. Echo provides an operator’s manual and a safety manual. Both must be read and un...

  • Page 2

    2 t able of c ontents introduction ..................................................................... 2 - the operator's manual ............................................. 2 - the safety manual ................................................... 2 safety ...........................................

  • Page 3

    H edge c lipper o perator ' s m anual 3 international symbols s afety manual safety symbols and important information throughout this manual and on the product itself, you will find safety alerts and helpful, informational messages pre - ceded by symbols or key words. The following is an explanation...

  • Page 4

    4 users of this product risk injury to themselves and others if the unit is used improperly and/or safety precautions are not followed. Proper clothing and safety gear must be worn when operating unit. Personal condition and safety equipment warning physical condition your judgment and physical dext...

  • Page 5

    H edge c lipper o perator ' s m anual 5 danger do not operate this product indoors or in inadequately ventilated areas. Engine exhaust contains poisonous emissions and can cause serious injury or death. Read the manuals • provide all users of this equipment with the operator’s manual and safety manu...

  • Page 6

    6 equipment check warning use only echo approved attachments. Serious injury may result from the use of a non-approved attachment com - bination. Echo, inc. Will not be responsible for the failure of cutting devices, attachments or accessories which have not been tested and approved by echo. Read an...

  • Page 7

    H edge c lipper o perator ' s m anual 7 d escription locate the safety decals on your unit. Make sure the decals are legible and that you understand and follow the instruc- tions on them. If a decal cannot be read, a new one can be ordered from your echo dealer. See parts ordering instructions for s...

  • Page 8

    8 1. Front handle with guard - comfortable, textured finish provides anti-slip grip. Guard protects hand from the blades. Warning decals are located on guard. 2. Blades - double reciprocating blades mounted to a blade support bar. The blades are double sided, capable of cut- ting on either side. 3. ...

  • Page 9

    H edge c lipper o perator ' s m anual 9 a ssembly this model is factory assembled. Note for normal cutting, echo strongly recommends the blade guard be installed. In extreme conditions, such as commercial cutting, or when cutting thick and/or dense branches, efficiency may be increased by trimming w...

  • Page 10

    10 a b install blade guard 1. Move stop switch to stop position. 2. Disconnect spark plug wire. Warning hedge clipper blades are very sharp. Touching them may lead to severe personal injury. Use a socket and extension when adjust - ing blade bolts or blade locknuts in order to keep hands at a safe d...

  • Page 11

    H edge c lipper o perator ' s m anual 11 warning operation of this equipment may create sparks that can start fires. This unit is equipped with a spark arrestor to prevent discharge of hot particles from the engine. Metal blade use also can create sparks if the blade strikes rocks, metal, or other h...

  • Page 12

    12 mixing instructions 1. Fill an approved fuel container with half of the required amount of gasoline. 2. Add the proper amount of 2-stroke oil to gasoline. 3. Close container and shake to mix oil with gasoline. 4. Add remaining gasoline, close fuel container, and remix. Important spilled fuel is a...

  • Page 13

    H edge c lipper o perator ' s m anual 13 starting cold engine warning hedge clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades whenever possible, and always wear gloves to protect hands. Note the blade cover is used for transportation and storage. ...

  • Page 14

    14 starting warm engine the starting procedure is the same as cold start except do not close the choke. Warning the blades must not move at idle, otherwise serious personal injury may result. Periodic carburetor adjustment may be necessary to assure blades do not move at idle. If blades move, readju...

  • Page 15

    H edge c lipper o perator ' s m anual 15 warning hedge clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades whenever possible, and always wear gloves to protect hands. 1. Always grip front and rear handles. 2. Hold trimmer firmly and squeeze throttle...

  • Page 16

    16 maintenance intervals component/system maintenance procedure skill level req'd daily or before use every refuel 3 months or 90 hours yearly 600 hours air filter inspect/clean 1 i / c * r * choke shutter inspect/clean 1 i / c fuel filter inspect/replace 1 i * i / r * fuel cap gasket inspect/replac...

  • Page 17

    H edge c lipper o perator ' s m anual 17 air filter level 1. Parts required: repower tm air & fuel filter kit 1. Close choke (cold start position [ ]). This prevents dirt from entering the carburetor throat when the air filter is removed. Brush accumulated dirt from air cleaner area. 2. Remove air f...

  • Page 18

    18 spark plug level 2. Parts required: repower tm tune-up kit important use only ngk bpm-8y spark plug (bpmr-8y in canada) other - wise severe engine damage may occur. 1. Remove spark plug and check for fouling, worn and rounded center electrode. 2. Clean the plug or replace with a new one. Do not s...

  • Page 19

    H edge c lipper o perator ' s m anual 19 1. Remove spark plug lead and spark plug. 2. Remove starter. 3. Remove bottom right (a) and bottom left (b) hex socket bolts from engine cover. 4. Remove heat shield bolt (c) from the engine cover. 5. Carefully pull engine cover forward disengaging muffler ga...

  • Page 20

    20 exhaust system spark arrestor screen level 2. Parts required: screen, gasket 1. Remove engine cover. See “cleaning cooling system” for step by step instructions. 2. Place piston at top dead center (tdc) to prevent carbon/dirt from entering cylinder. 3. Remove exhaust guide (a), gasket (b), and sc...

  • Page 21

    H edge c lipper o perator ' s m anual 21 exhaust port cleaning level 2. Parts required: as needed: heat shield 1. Remove spark plug lead from spark plug, and remove engine cover. 2. Place piston at top dead center. Remove muffler (a) and heat shield (b). 3. Use a wood or plastic scraping tool to cle...

  • Page 22

    22 carburetor adjustment warning the blades must not move at idle, otherwise serious personal injury may result. Periodic carburetor adjustment may be necessary to assure blades do not move at idle. If blades move, readjust carburetor according to these instructions, or see your echo dealer. Engine ...

  • Page 23

    H edge c lipper o perator ' s m anual 23 lubrication blades level 1. Parts required: 20w engine oil (lubrication), 50-50 mixture of kerosene and 20w oil (cleaning). Warning hedge clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades whenever possible,...

  • Page 24

    24 sharpening blades level 2. Parts required: none warning hedge clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades whenever possible, and always wear gloves to protect hands. 1. Clean dirt from the grease fitting (a). 2. Carefully pump grease into...

  • Page 25

    H edge c lipper o perator ' s m anual 25 blade adjustment level 2. Parts required: none warning hedge clipper blades are very sharp. Touching them may lead to severe personal injury. Use a socket and extension when adjust - ing blade bolts or blade locknuts in order to keep hands at a safe distance ...

  • Page 26

    26 danger fuel vapors are extremely flammable and may cause fire and/or explosion. Never test for ignition spark by ground- ing spark plug near cylinder plug hole, otherwise serious personal injury may result. T roubleshooting t r a h c g n i t o o h s e l b u o r t m e l b o r p e n i g n e m e l b...

  • Page 27

    H edge c lipper o perator ' s m anual 27 s torage warning during operation the muffler or catalytic muffler and surrounding cover become hot. Always keep exhaust area clear of flammable debris during transportation or when storing, otherwise serious personal injury may result. Long term storage (ove...

  • Page 28

    28 model ------------------------------------------hc-150 length ---------------------------------------------1,040 mm (41.0 in.) width ----------------------------------------------240 mm (9.45 in.) height ---------------------------------------------200 mm (7.87 in.) weight, dry ------------------...

  • Page 29

    H edge c lipper o perator ' s m anual 29 echo limited warranty statement for product sold in usa and canada beginning 01/01/2010 echo's responsibility echo incorporated’s limited warranty, provides to the original purchaser that this echo product is free from defects in material and workmanship. Und...

  • Page 30

    30 purchased repair parts, short blocks and accessories • 90-day residential, or non-income producing warranty • 30-day commercial, institutional, agricultural, industrial, income producing, or rental application warranty attention two-stroke engine power product owners this echo two-stroke engine p...

  • Page 31

    H edge c lipper o perator ' s m anual 31 echo incorporated emission control warranty statement for echo and shindaiwa brands the environmental protection agency (epa) and the california air resources board (c.A.R.B.) and echo incorporated (echo inc.) are pleased to explain the emission control syste...

  • Page 32

    Echo, incorporated 400 o akwood r oad l ake z urich , il 60047 www.Echo-usa.Com s69811001001/s69811999999 s76112001001/s76112999999 dealer? Call 1-800-432-echo 1-800-432-3246 or www.Echo-usa.Com consumer product support 1-800-673-1558 8:30 - 4:30 m on - f ri c.S.T. S ervicing i nformation parts / se...