Echo MS-53BPE Use and care manual - page 4

The sprayer includes all hardware necessary for installing the pump handle. Install the pump handle 

into the base (A). Center the hole in the handle between the cut-out on the bottom of the tank base (B). 

Push the “C” clip over the pump handle while aligning the nub on the clip with the hole in the handle 

(C). Slide washer over pump linkage  (short end) (D). Slide pump arm linkage (short end) through 

pump handle at the bottom of the tank (D & E). Slide a second washer over the linkage and insert the 

cotter pin through the hole in linkage (E). Position ball over top of pump (F). The pump assembly can 

be rotated to orient the pump outlet into desired position (G). Rotate handle down until ball is seated 

in top of pump (F and G). Tighten pump retainer nut (F). Do not over tighten. Press boot over retainer 

nut (H). Insure pump locking nut is tight (G).

INSTALLING THE PUMP HANDLE

3E

SPRAYER COMPONENTS & USE INFORMATION, Continued

A

Pump 

Handle

“C” Clip

D

E

Pump Arm 

Linkage

A

B

C

G

Pump 

outlet

Pump 

Locking Nut

F

Boot

Retainer 

Nut

Ball

H

O-ring

Wand

Retaining Nut

Shut-off

Valve

WAND ASSEMBLY

1.  Make sure the o-ring is installed on the end of the wand. Insert the wand into shut-off valve.

2.  Turn and tighten the retaining nut clock-wise onto the shut-off valve.