Echo MS-53BPE Use and care manual - page 7
Shut-off leaks
Connections loose
Tighten connection
Worn or damaged shut-off
Rebuild or replace the shut-off valve
Wand assembly leaks
Connections loose
Tighten connection
Damaged or worn o-ring/gasket
Replace o-ring/gasket
Nozzle assembly leaks
Connections loose
Tighten connection
Damaged or worn o-ring/gasket
Replace o-ring/gasket
Hose leaking at shut-off
Connection loose
Tighten retaining nut
Damaged or worn o-ring/gasket
Replace o-ring/gasket
Hose leaking at pump outlet
Connection loose
Tighten retaining nut
Damaged or worn o-ring/gasket
Replace o-ring/gasket
Upward pumping action difficult
Inlet openings in bottom of piston
Remove piston cylinder and clean openings
cylinder clogged
(see section on Piston Cylinder Disassembly
and Rebuild)
Piston cylinder check valve stuck
Remove piston cylinder check valve cartridge-
Clean, rebuild or replace (see section on Piston
Cylinder Disassembly and rebuild)
Downward pumping action difficult
Pressure chamber check valve stuck
Remove piston cylinder check valve cartridge-
Clean, rebuild or replace (see section on Piston
Cylinder Disassembly and rebuild)
Decline in pump performance (cannot
Dirt or debris or wear in one or both
Remove both check valves and clean, rebuild
achieve pressure and/or doesn’t hold
check valves
or replace (see section on Piston Cylinder
pressure)
Disassembly and Rebuild and also section
on Pump Disassembly and rebuild)
Piston cylinder inside diameter
Remove piston cylinder and check inside
surface worn
diameter for wear- replace if necessary (see
section on Piston Cylinder Disassembly
and Rebuild)
Plunger cup worn
Remove pump assembly and check plunger
cup for wear-replace if necessary (see section
on Pump Disassembly and Rebuild)
Damaged pressure chamber housing
Remove pump assembly and replace
pressure chamber housing (see section on
Pump Disassembly and Rebuild)
Incorrect Assembly of plunger and/or
Refer to section on Pump Disassembly and
check valve components
Rebuild and Piston Cylinder Disassembly and
Rebuild
STORING / MAINTAINING YOUR SPRAYER
• The sprayer should be stored out of direct sunlight in a cool dry space.
• Before freezing weather make sure to drain all liquid in the tank, pump, pressure cylinder, hose,
shut-off valve, wand and nozzle, to avoid liquid expansion and cracking in the sprayer components
(See “Cleaning” section). Lock the shut-off valve in the “open” position.
• When service is required call your nearest dealer and always insist on original manufactured
replacement parts.
• Inspect the hose, wand, pump, tank and shut-off valve for wear, damage or leaks on a regular basis
and repair defects promptly.
• Every year prior to spraying remove felt gasket (see Pump Disassembly and Rebuild) and saturate
with a light oil. Oil periodically thru out the season as needed.
TROUBLE SHOOTING YOUR SPRAYER
Symptom
Possible Reason
Correction
6E