Echo PB-265ESL Service Data

Other manuals for PB-265ESL: Operator's Manual

Summary of PB-265ESL

  • Page 1

    Pb-265esl 21-25g-00 1 introduction we are constantly working on technical im- provement of our products. For this reason, technical data, equipment and design are subject to change without notice. All speci- fications and directions in this service data are based on the latest products infor- mation...

  • Page 2

    Service information pb-265esl 2 1 service information 1-1 speci fi cations dimensions length* mm(in) 305 (12.0) width* mm(in) 410 (16.1) height mm(in) 435 (17.1) dry weight** kg(lb) 6.1 (13.4) engine type kioritz, air-cooled, two-stroke, single cylinder rotation anticlockwise as viewed from the outp...

  • Page 3

    Service information pb-265esl 3 1-2 technical data engine idling speed r/min 2800 - 3200 wide open throttle speed r/min 6700 - 7200 compression pressure mpa (kgf/cm 2 ) (psi) 0.83 (8.4) (120) ignition system spark plug gap mm (in) 0.6 - 0.7 (0.024 - 0.028) minimum secondary voltage at 1500 r/min kv ...

  • Page 4

    Service information pb-265esl 4 1-3 torque limits descriptions size kgf•cm 2n•m in•lbf starter starter pawl m 8* 130 - 150 13 - 15 115 - 130 system starter case m 5 † 20 - 40 2 - 4 17 - 35 ignition ignition coil m 4 35 - 45 3.5 - 4.5 30 - 40 system spark plug m 14 150 - 170 15 - 17 130 - 150 fuel ca...

  • Page 5

    Service information pb-265esl 5 1-5 service limits description mm (in) a cylinder bore when plating is worn and aluminum can be seen b piston outer diameter min. 33.91 (1.335) c piston pin bore max. 8.030 (0.3161) d piston ring groove max. 1.3 (0.051) e piston ring side clearance max. 0.1 (0.004) f ...

  • Page 6

    Service information pb-265esl 6 echo ignition air gap gauge #.014 = .35mm p/n 91004 0 0.4 50 0.8 1.2 1. Mpa 0 key part number description used for: 1 897801-33330 tachometer pet-1000 measuring engine speed 2 363018-00310 washer installing crankcase oil seal of starter side 3 895610-79920 l-hex wrenc...

  • Page 7

    Service information pb-265esl 7 2 carburettor adjustment proceduter 2-1 general adjusting rules a. Before starting the unit for adjustment, check the following items. 1. The correct spark plug must be clean and properly gapped. 2. The air fi lter element must be clean and properly installed. 3. The ...

  • Page 8

    Service information pb-265esl 8 2-3 adjusting carburettor 1. Start engine and warm it up alternating engine speed between wot and idle every 10 seconds for 1 minute. 2. Adjust idle mixture needle (a) with 2.5 mm blade screwdriver (e) to reach maximum engine speed just before drop off. 3. Set idle sp...