1. DL manuals
  2. Echo
  3. Blower
  4. PB-413H
  5. Operator's Manual

Echo PB-413H Operator's Manual

Other manuals for PB-413H: Operator's Manual, Starting Instructions

Summary of PB-413H

  • Page 1

    Power blower operator's manual models pb-413h serial number 02001001 - 02999999 pb-413t serial number 02001001 - 02999999 warning danger read rules for safe operation and all instructions carefully. Echo provides this operator's manual which must be read and understood for proper and safe operation....

  • Page 2

    2 i ntroduction welcome to the echo family. This echo product was designed and manufactured to provide long life and on-the-job- dependability. Read and understand this manual. You will find it easy to use and full of helpful operating tips and safety messages. The operator ' s manual read and under...

  • Page 3: Category II

    3 p ower b lower o perator ' s m anual important note m anual s afety s ymbols and i mportant i nformation throughout this manual and on the product itself, you will find safety alerts and helpful, information messages preceded by symbols or key words. The following is an explanation of those symbol...

  • Page 4

    4 international symbols s afety i nstructions personal condition and safety equipment warning danger power blower users risk injury to themselves and others if the power blower is used improperly and/or safety precautions are not followed. Proper clothing and safety gear must be worn when operating ...

  • Page 5

    5 p ower b lower o perator ' s m anual extended operation / extreme conditions vibration and cold it is believed that a condition called raynaud’s phenomenon, which affects the fingers of certain individuals may be brought about by exposure to vibration and cold. Exposure to vibration and cold may c...

  • Page 6

    6 safe operation warning danger do not operate this product indoors or in inadequately ventilated areas. Engine exhaust contains poisonous emissions and can cause serious injury or death. • review area to be cleared. Look for potential hazards such as stones or metal objects. • spectators and fellow...

  • Page 7

    7 p ower b lower o perator ' s m anual d escription pb-413h contents __ 1 - power head __ 1 - flex pipe __ 1 - pipe w/swivel __ 1 - straight pipe __ 1 - curved pipe __ 1 - operator's manual __ 1 - warranty registration card __ 1 - echo emissions and warranty statement __ 1 - plastic bag __ 2 - clamp...

  • Page 8

    8 1. Safety decal - lists important safety precautions. 2. Spark plug - provides spark to ignite fuel mixture. 3. Spark arrestor - catalytic muffler / muffler - the muffler or catalytic muffler controls exhaust noise and emission. The spark arrestor screen prevents hot, glowing particles of carbon f...

  • Page 9

    9 p ower b lower o perator ' s m anual 1 2 3 7 10 11 12 13 14 15 5 6 4 pb-413t contents __ 1 - power head __ 1 - flex pipe __ 1 - pipe w/swivel __ 1 - straight pipe __ 1 - curved pipe __ 1 - operator's manual __ 1 - warranty registration card __ 1 - echo emissions and warranty statement __ 1 - plast...

  • Page 10

    10 1. Safety decal - lists important safety precautions. 2. Spark plug - provides spark to ignite fuel mixture. 3. Spark arrestor - catalytic muffler / muffler - the muffler or catalytic muffler controls exhaust noise and emission. The spark arrestor screen prevents hot, glowing particles of carbon ...

  • Page 11

    11 p ower b lower o perator ' s m anual s pecifications model ----------------------------------------------------- pb-413h, pb-413t length ------------------------------------------------------- 320 mm (12.6 in.) width -------------------------------------------------------- 460 mm (18.1 in.) heigh...

  • Page 12

    12 a ssembly pb-413h warning danger never perform maintenance or assembly procedures with engine running or serious personal injury may result. Install blower pipes / stick handle 1. Assemble clamps (a) onto both ends of flexible pipe (b). 2. Assemble straight pipe with swivel (c) into flexible pipe...

  • Page 13

    13 p ower b lower o perator ' s m anual pb-413t warning danger never perform maintenance or assembly procedures with engine running or serious personal injury may result. Install blower pipes 1. Assemble clamps (a) onto both ends of flexible pipe (b). 2. Assemble straight pipe with swivel (c) into f...

  • Page 14

    14 p re -o peration fuel fuel requirements gasoline - use 89 octane [r+m/2] (mid grade or higher) gasoline known to be good quality. Gasoline may contain up to 15% mtbe (methyl tertiary-butyl ether). Gasohol containing methyl (wood) alcohol is not approved. Two stroke oil - a two-stroke engine oil m...

  • Page 15

    15 p ower b lower o perator ' s m anual o peration • recoil starter: use short pulls - only 1/2-2/3 of rope length for starting. Do not allow the rope to snap back in. Always hold the unit firmly. • (pb-413h): rotate spring loaded throttle arm downward to a comfort- able operating position. Starting...

  • Page 16

    16 starting warm engine pb-413h 1. Throttle lever move throttle lever (a) to idle detent position. Pb-413t 1. Throttle lever/stop switch move throttle lever (a) forward to idle position. Slide stop switch (b) forward to run position. Pb-413h, pb-413t 2. Recoil starter pull recoil starter handle (e) ...

  • Page 17

    17 p ower b lower o perator ' s m anual operating blower warning danger always wear safety glasses, hearing protection, a face filter mask and take all safety precautions or serious personal injury may result. Do not point the blower pipe in the direction of people or pets. Read the safety section o...

  • Page 18

    18 m aintenance your echo blower is designed to provide many hours of trouble free service. Regular scheduled maintenance will help your blower achieve that goal. If you are unsure or are not equipped with the necessary tools, you may want to take your unit to an echo service dealer for maintenance....

  • Page 19

    19 p ower b lower o perator ' s m anual air filter level 1. Tools required: 25 - 50 mm (1 - 2 in.) medium bristle paint brush. Parts required: tune up kit p/n 90070 note clean daily. 1. Close choke (cold start position). This prevents dirt from entering the carburetor throat when the air filter is r...

  • Page 20

    20 spark plug level 1. Tools required: 3/4 in. Spark plug deep socket, feeler gauge (preferably a wire gauge) parts required: tune up kit p/n 90070 1. Remove spark plug , and check for fouling, worn and rounded center electrode. 2. Clean the plug or replace with a new one. Do not sand blast to clean...

  • Page 21

    21 p ower b lower o perator ' s m anual cleaning cylinder fins 1. Disconnect spark plug lead from spark plug. 2. Remove engine cover (five screws), pull cover away from engine. 3. Clean cylinder fins (a) to allow cooling air to pass freely. 4. Replace cover and tighten screws. 5. Connect spark plug ...

  • Page 22

    22 carburetor adjustment engine break-in new engines must be operated a minimum duration of two tanks of fuel break-in before carburetor adjustments can be made. During the break-in period your engine performance will increase and exhaust emissions will stabilize. Idle speed can be adjusted as requi...

  • Page 23

    23 p ower b lower o perator ' s m anual initial adjustment 1. With engine off, turn hi speed screw (c) counterclockwise to stop. 2. Turn lo speed screw (b) midway between stops. 3. Turn idle screw (a) until tip of screw just touches throttle plate; then turn three (3) turns clockwise. Final adjustme...

  • Page 24

    24 t roubleshooting warning danger fuel vapors are extremely flammable and may cause fire and/or explosion. Never test for ignition spark near an open spark plug opening, otherwise serious personal injury may result. T r a h c g n i t o o h s e l b u o r t m e l b o r p k c e h c s u t a t s e s u a...

  • Page 25

    25 p ower b lower o perator ' s m anual 2. Place the stop switch in the "stop" position. 3. Remove accumulation of grease, oil, dirt and debris from exterior of unit. 4. Perform all periodic lubrication and services that are required. 5. Tighten all screws and nuts. 6. Drain the fuel tank completely...

  • Page 26: Notes

    26 notes.

  • Page 27: Notes

    27 p ower b lower o perator ' s m anual notes.

  • Page 28

    Echo, incorporated 400 o akwood r oad l ake z urich , il 60047 www.Echo-usa.Com dealer? Call 1-800-432-echo or www.Echo-usa.Com consumer product support 1-800-673-1558 8:30 - 4:30 mon - fri c.S.T. S ervicing i nformation parts genuine echo parts and echo repower™ parts and assemblies for your echo p...