Echo PB-413H Starting Instructions

16

STARTING

COLD

ENGINE

• Recoil starter:  Use short pulls - only 1/2-2/3 of rope length for

starting.  Do not allow the rope to snap back in.  Always hold the unit

firmly.

• (PB-413H): Rotate spring loaded throttle arm downward to a comfort-

able operating position.

PB-413H

1. Throttle Lever

Move throttle lever (A) to Wide Open Throttle position.

PB-413T

1. Throttle Lever/Stop Switch

Move throttle lever (A) rearward to Wide Open Throttle position.

Slide stop switch (B) forward to run position.

PB-413H, PB-413T

2. Choke

Move choke (C) up to Cold Start position ( 

 ).

3. Purge Bulb

Pump purge bulb (D) until fuel is visible and flows freely in the

clear fuel tank return line. Pump bulb an additional 4 or 5 times.

4. Recoil Starter

Pull recoil starter handle (E) until engine fires, or a maximum of  5

pulls.

5. Choke

After engine fires (or 5 pulls), move choke lever to Run (

)

position.  Keep throttle lever in wide open throttle position, and

pull recoil starter handle until engine starts and runs.

NOTE

If engine does not start with choke in “Run” position after 5 pulls,

move choke to “Cold Start” (

 ) position, and repeat steps 4 & 5.

6. Throttle Lever

Move throttle lever to IDLE position, and allow engine to warm up

before use.

7. Throttle Lever

After engine warm-up, move throttle lever gradually to increase

engine RPM to desired operating speed.

A

PB-413H

PB-413T

B

A

E

C

D