- DL manuals
- Echo
- Kitchen Appliances
- PB-610
- Operator's Manual
Echo PB-610 Operator's Manual - page 19
19
P
OWER
B
LOWER
O
PERATOR
'
S
M
ANUAL
A
D
C
B
E
EXHAUST
SYSTEM
Spark Arrestor Screen
Level 2.
Tools required:
Cross head screwdriver, soft metal brush
Parts Required:
Spark arrestor screen. Gaskets (3)
IMPORTANT
Carbon deposits in muffler will cause a drop in engine output and
overheating. Spark arrestor screen must be checked periodically.
1. Remove spark plug and engine cover (five screws).
2. Remove spark arrestor cover (A), gaskets (B, C, D) and spark
arrestor screen (E) from muffler.
NOTE
When cleaning carbon deposits, be careful not to damage the
catalytic element inside muffler.
3. Clean carbon deposits from muffler components.
4. Replace screen if it is cracked, plugged, or has holes burned
through.
5. Assemble components in reverse order.
Summary of PB-610
Page 1
Power blower operator's manual model pb-610 warning read rules for safe operation and all instructions carefully. Echo provides this operator's manual which must be read and understood for proper and safe operation. X753002791 01/09 x7531122001.
Page 2: ’
2 t able of c ontents introduction .................................................................. 2 - the operator's manual .......................................... 2 safety ............................................................................ 3 - manual safety symbols and important inf...
Page 3
3 p ower b lower o perator ' s m anual s afety manual safety symbols and important information throughout this manual and on the product itself, you will find safety alerts and helpful, informational messages preceded by symbols or key words. The following is an explanation of those symbols and key ...
Page 4
4 physical condition your judgment and physical dexterity may not be good: • if you are tired or sick, • if you are taking medication, • if you have taken alcohol or drugs. Operate unit only if you are physically and mentally well. Eye protection wear eye protection that meets ansi z87.1 or ce requi...
Page 5
5 p ower b lower o perator ' s m anual repetitive stress injuries it is believed that overusing the muscles and tendons of the fingers, hands, arms, and shoulders may cause soreness, swelling, numbness, weakness, and extreme pain in those areas. Certain repetitive hand activities may put you at a hi...
Page 6
6 important engine information engine family: 9ehxs.0585ka displacement: 21.2 cc emission compliance period : 300 hrs. This engine meets u.S. Epa ph2 exh and 2007 and later california exh and evap emission regula- tions for s.O.R.E.. Refer to owner's manual for maintenance specifications and adjustm...
Page 7: Category III
7 p ower b lower o perator ' s m anual 1 2 3 4 5 6 7 8 10 11 12 9 13 14 hot decal (near muffler) general warning decal (located on top of blower housing) p/n x505002310 p/n 89016009461 72 category iii db(a) measured at 50 ft. (15m) per ansi b175.2 p/n x508000150 sound label (located on blower housin...
Page 8
8 1. Air cleaner - contains replaceable air filter element. 2. Spark plug - provides spark to ignite fuel mixture. 3. Spark arrestor - catalytic muffler / muffler - the muffler or catalytic muffler controls exhaust noise and emission. The spark arrestor screen prevents hot, glowing particles of carb...
Page 9
9 p ower b lower o perator ' s m anual a ssembly warning never perform maintenance or assembly procedures with engine running or serious personal injury may result. Install blower pipes / stick handle 1. Assemble clamps (a) onto both ends of flexible pipe (b). 2. Assemble swivel pipe (c) into flexib...
Page 10
10 notice: use of unmixed, improperly mixed, or fuel older than 90 days, (stale fuel), may cause hard starting, poor performance, or severe engine damage and void the product warranty. Read and follow instructions in the storage section of this manual. Fuel warning alternative fuels, such as e-20 (2...
Page 11
11 p ower b lower o perator ' s m anual handling fuel danger fuel is very flammable. Use extreme care when mixing, storing or handling or serious personal injury may result. • use an approved fuel container. • do not smoke near fuel. • do not allow flames or sparks near fuel. • fuel tanks/cans may b...
Page 12
12 starting cold engine • check unit for loose nuts, bolts and screws daily. • recoil starter: use short pulls - only 1/2-2/3 of rope length for starting. Do not allow the rope to snap back in. Always hold the unit firmly. • rotate throttle handle downward to a comfortable operating position. 1. Thr...
Page 13
13 p ower b lower o perator ' s m anual starting warm engine the starting procedure is the same as cold start except do not close the choke. 1. Throttle lever move throttle lever (a) to "slow" (start) position. 2. Purge bulb pump purge bulb (c) until fuel is visible and flows freely in the clear fue...
Page 14
14 3. Set engine speed with throttle lever (a). 4. Use lower speed to blow dry grass and leaves from walks, patios and drives. 5. Additional speed may be necessary to clean leaves from a lawn or flower bed. 6. Higher speed may be necessary to move gravel, dirt, snow, bottles or cans from a driveway,...
Page 15
15 p ower b lower o perator ' s m anual m aintenance warning moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop before removi...
Page 16
16 warning allow the engine and muffler to completely cool before perform- ing any maintenance activity. Air filter level 1. Tools required: 25 - 50mm (1 - 2 in.) cleaning brush parts required: tune up kit note always brush dirt and debris away from air cleaner area prior to cleaning air filter. 1. ...
Page 17
17 p ower b lower o perator ' s m anual spark plug level 1. Tools required: 3/4 in. Spark plug deep socket, feeler gauge parts required: repower tm tune up kit important use only ngk bpm-8y spark plug (bpmr-8y in canada) otherwise severe engine damage may occur. 1. Remove spark plug and check for fo...
Page 18
18 cooling systems cleaning level 2. Tools required: 25 - 50 mm (1 - 2 in.) cleaning brush, cross head screwdriver parts required: none, if you are careful. Important to maintain proper engine operating temperatures, cooling air must pass freely through the cylinder fin area. This flow of air carrie...
Page 19
19 p ower b lower o perator ' s m anual a d c b e exhaust system spark arrestor screen level 2. Tools required: cross head screwdriver, soft metal brush parts required: spark arrestor screen. Gaskets (3) important carbon deposits in muffler will cause a drop in engine output and overheating. Spark a...
Page 20
20 exhaust port cleaning level 2. Tools required: 4 & 5 mm hexagon wrench, cross head screwdriver, wood or plastic scraper parts required: as needed: heat shield 1. Remove spark plug lead from spark plug, and remove engine or muffler cover (5 screws). 2. Place piston at top dead center. Remove muffl...
Page 21
21 p ower b lower o perator ' s m anual carburetor adjustment engine break-in new engines must be operated a minimum duration of two tanks of fuel break-in before carburetor adjustments can be made. During the break-in period your engine performance will increase and exhaust emissions will stabilize...
Page 22
22 before adjustment check that: • air filter is clean and properly installed. • spark arrestor screen and muffler are free of carbon. • blower pipes are installed. Initial adjustment 1. With engine off, turn hi speed screw (c) counterclockwise to stop. 2. Turn lo speed screw (b) midway between stop...
Page 23
23 p ower b lower o perator ' s m anual danger fuel vapors are extremely flammable and may cause fire and/or explosion. Never test for ignition spark by grounding spark plug near cylinder plug hole, otherwise serious personal injury may result. T roubleshooting t r a h c g n i t o o h s e l b u o r ...
Page 24
24 2. Place the stop switch in the "stop" position. 3. Remove accumulation of grease, oil, dirt and debris from exterior of unit. 4. Perform all periodic lubrication and services that are required. 5. Tighten all screws and nuts. 6. Drain the fuel tank completely and pull the recoil starter handle s...
Page 25
25 p ower b lower o perator ' s m anual s pecifications model --------------------------------------------------------- pb-610 length ------------------------------------------------------------ 325 mm (12.8 in.) width ------------------------------------------------------------- 520 mm (20.5 in.) h...
Page 26
26 notes.
Page 27
27 p ower b lower o perator ' s m anual notes.
Page 28
Dealer? Call 1-800-432-echo 1-800-432-3246 or www.Echo-usa.Com echo, incorporated 400 oakwood road lake zurich, il 60047 www.Echo-usa.Com additional or replacement manuals safety manuals in english/spanish or english/french are available, free of charge, from your echo dealer or at www.Echo-usa.Com....