1. DL manuals
  2. Echo
  3. Tiller
  4. Power Blend TC-210
  5. Operator's Manual

Echo Power Blend TC-210 Operator's Manual

Manual is about: Tiller/Cultivator

Summary of Power Blend TC-210

  • Page 1

    X7504083609 © 4/2016 echo inc. Operator’s manual specifications, descriptions and illustrative material in this literature are as accurate as known at the time of publication, but are subject to change without notice. Illustrations may include optional equipment and accessories, and may not include ...

  • Page 2: Table of Contents

    Table of contents tc-210 2 x7504083609 © 4/2016 echo inc. Table of contents table of contents .............................................................................................. 2 introduction ...................................................................................................

  • Page 3: Tc-210

    X7504083609 3 © 4/2016 echo inc. Tc-210 introduction introduction welcome to the echo family. This echo product was designed and manufactured to provide long life and on-the-job dependability. Read and understand this manual. You will find it easy to use and full of helpful operating tips and safety...

  • Page 4: Safety

    Safety tc-210 4 x7504083609 © 4/2016 echo inc. Product registration to ensure trouble free warranty coverage it is important that you register your echo equipment on-line at www.Echo-usa.Com or by filling out the product registration sheet included in this manual. Registering your product confirms y...

  • Page 5: Tc-210

    X7504083609 5 © 4/2016 echo inc. Tc-210 safety the enclosed message provides information necessary for the protection of the unit. Note: this enclosed message provides tips for use, care and maintenance of the unit. Circle and slash symbol this symbol means the specific action shown is prohibited. I...

  • Page 6: Safety

    Safety tc-210 6 x7504083609 © 4/2016 echo inc. Personal condition and safety equipment users of this product risk injury to themselves and others if the unit is used improperly and/or safety precautions are not followed. Proper clothing and safety gear must be worn when operating unit. Physical cond...

  • Page 7: Tc-210

    X7504083609 7 © 4/2016 echo inc. Tc-210 safety • if you have taken alcohol or drugs. Operate unit only if you are physically and mentally well. Eye protection ◆ eye protection that meets ansi z87.1 or ce requirements must be worn whenever you operate the unit. ◆ for additional safety, a full-face sh...

  • Page 8: Safety

    Safety tc-210 8 x7504083609 © 4/2016 echo inc. Heavy protective clothing can increase operator fatigue, which may lead to heat stroke. Schedule heavy work for early morning or late afternoon hours when temperatures are cooler. The components of this machine generate an electromagnetic field during o...

  • Page 9: Tc-210

    X7504083609 9 © 4/2016 echo inc. Tc-210 safety repetitive stress injuries (rsi) it is believed that overusing the muscles and tendons of the fingers, hands, arms, and shoulders may cause soreness, swelling, numbness, weakness, and extreme pain in those areas. Certain repetitive hand activities may p...

  • Page 10: Safety

    Safety tc-210 10 x7504083609 © 4/2016 echo inc. • never allow children or uninstructed adults to operate the unit. • keep bystanders and animals a minimum of 15m (50 ft.) away while operating unit. • keep away from rotating parts. • do not hold or carry unit in a manner that will permit tines to con...

  • Page 11: Tc-210

    X7504083609 11 © 4/2016 echo inc. Tc-210 emission control ◆ always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop before removing obstructions, clearing debris, or servicing unit. ◆ do not start or operate unit unless all guards and protective covers ...

  • Page 12: Emission Control

    Emission control tc-210 12 x7504083609 © 4/2016 echo inc. Product emission durability (emission compliance period) the 50 or 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine emissions output meets applicable emissions regulations, provided that ...

  • Page 13: Tc-210

    X7504083609 13 © 4/2016 echo inc. Tc-210 description description locate the safety decal(s) on your unit. Make sure the decal(s) is legible and that you understand and follow the instructions on it. If a decal cannot be read, a new one can be ordered from your echo dealer. See parts ordering instruc...

  • Page 14: Description

    Description tc-210 14 x7504083609 © 4/2016 echo inc. 1. Stop switch - toggle switch mounted on throttle handle. Move switch forward to "run" position to run, back to "stop" position to stop unit. 2. Throttle trigger - spring loaded to return to idle when released. When accelerating, pull trigger gra...

  • Page 15: Tc-210

    X7504083609 15 © 4/2016 echo inc. Tc-210 contents contents the echo product you purchased has been factory pre-assembled for your convenience. Due to packaging restrictions, some assembly may be necessary. After opening the carton, check for damage. Immediately notify your retailer or echo dealer of...

  • Page 16: Assembly

    Assembly tc-210 16 x7504083609 © 4/2016 echo inc. Assembly 1. Lay powerhead assembly down so that shield label faces upward. Place top handle assembly to front. 2. Loosely assemble lower handle/ kick stand assembly using carriage bolt (a), eye plates (b), lockwasher (c) and locknut (d) in rear assem...

  • Page 17: Tc-210

    X7504083609 17 © 4/2016 echo inc. Tc-210 assembly 6. Remove carriage bolts (f), lockwashers (g), and nuts (h) from top handle assembly. 7. Place top handle assembly between lower handles, align mounting holes and attach using carriage bolts (f), lockwashers (g), and nuts (h). Carriage bolts must be ...

  • Page 18: Operation

    Operation tc-210 18 x7504083609 © 4/2016 echo inc. Operation moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop before removi...

  • Page 19: Tc-210

    X7504083609 19 © 4/2016 echo inc. Tc-210 operation two stroke oil - a two-stroke engine oil meeting iso-l-egd (iso/cd 13738) and j.A.S.O. Fd standards must be used. Echo brand premium power blend x ™ universal 2-stroke oil meets these standards. Engine problems due to inadequate lubrication caused b...

  • Page 20: Operation

    Operation tc-210 20 x7504083609 © 4/2016 echo inc. Spilled fuel is a leading cause of hydrocarbon emissions. Some states may require the use of automatic fuel shut-off containers to reduce fuel spillage. After use • do not store a unit with fuel in its tank. Leaks can occur. Return unused fuel to an...

  • Page 21: Tc-210

    X7504083609 21 © 4/2016 echo inc. Tc-210 operation move choke lever (b) to cold start position ( ). Throttle must remain at idle for starting. 4. Purge bulb pump purge bulb (c) 5-10 times until fuel is visible and flows freely in the clear fuel tank return line. 5. Recoil starter firmly hold unit do...

  • Page 22: Operation

    Operation tc-210 22 x7504083609 © 4/2016 echo inc. Starting warm engine the starting procedure is the same as cold start except do not close the choke. 1. Stop switch move stop switch button (a) to run position. 2. Purge bulb pump purge bulb (c) until fuel is visible in the “clear” fuel return line....

  • Page 23: Tc-210

    X7504083609 23 © 4/2016 echo inc. Tc-210 operation tilling/cultivating engine exhaust is hot, and contains carbon monoxide (co), a poison gas. Breathing co can cause unconsciousness, serious injury, or death. Exhaust can cause serious burns. Always position unit so that exhaust is directed away from...

  • Page 24: Operation

    Operation tc-210 24 x7504083609 © 4/2016 echo inc. Tilling - recommended tilling depth is 15-20 cm (6 - 8 inches) install tines with individual tines angled forward, toward front of unit. (see tine removal/cleaning/installation) • use a forward/backward motion to till soil. Allow tines to dig into s...

  • Page 25: Tc-210

    X7504083609 25 © 4/2016 echo inc. Tc-210 maintenance maintenance moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop before re...

  • Page 26: Maintenance

    Maintenance tc-210 26 x7504083609 © 4/2016 echo inc. Important note - time intervals shown are maximum. Actual use and your experience will determine the frequency of required maintenance. * replacement is recommended based on the finding of damage or wear during inspection maintenance procedure not...

  • Page 27: Tc-210

    X7504083609 27 © 4/2016 echo inc. Tc-210 maintenance 4. If filter can be reused, be certain it: • fits tightly in the air filter cavity. • is installed with the original side out. 5. Install air filter cover. Note: carburetor adjustment may be needed after air filter cleaning/ replacement. See carbu...

  • Page 28: Maintenance

    Maintenance tc-210 28 x7504083609 © 4/2016 echo inc. Use only ngk bpm-8y spark plug (bpmr-8y in canada) otherwise severe engine damage may occur. 1. Remove spark plug and check for fouling, worn and rounded center electrode. 2. Clean the plug or replace with a new one. Do not sand blast to clean. Re...

  • Page 29: Tc-210

    X7504083609 29 © 4/2016 echo inc. Tc-210 maintenance 1. Remove throttle cable end from the carburetor swivel. 2. Remove starter cover. Note: the throttle cable remains assembled to the starter cover. 3. Disconnect spark plug lead. 4. Remove cylinder cover. (a) 5. Use brush to remove dirt from the cy...

  • Page 30: Maintenance

    Maintenance tc-210 30 x7504083609 © 4/2016 echo inc. 1. Remove starter cover and cylinder cover. 2. Remove exhaust guide (a), gasket (b), and screen (c) from muffler body. 3. Clean carbon deposits from muffler components. Note: when cleaning carbon deposit, be careful not to damage the catalytic ele...

  • Page 31: Tc-210

    X7504083609 31 © 4/2016 echo inc. Tc-210 maintenance carburetor adjustment level 2. Engine break-in new engines must be operated a minimum duration of two tanks of fuel break-in before carburetor adjustments can be made. During the break-in period your engine performance will increase and exhaust em...

  • Page 32: Maintenance

    Maintenance tc-210 32 x7504083609 © 4/2016 echo inc. 2. Start engine and run for several minutes to reach operating temperature. 3. Stop engine. Turn hi (a) speed needle ccw (counter clockwise) to stop. Turn lo (b) speed needle midway between full ccw and cw (clockwise) stops. 4. Idle speed adjustme...

  • Page 33: Tc-210

    X7504083609 33 © 4/2016 echo inc. Tc-210 maintenance gear housing 1. Remove tines (see tine removal/ cleaning - installation below). 2. Remove gear case cover (a). Be careful not to tear sealing gasket (c). 3. Support tiller with exposed gear case (d) upward. Add grease until nearly level with top o...

  • Page 34: Troubleshooting

    Troubleshooting tc-210 34 x7504083609 © 4/2016 echo inc. 5. Slide tine on shaft, long hub first. D- hole (hole with flat side) goes to the outside. (d-hole in outer hub aligns with flat on shaft.). 6. Install retaining pin (e). Troubleshooting engine problem troubleshooting chart problem check statu...

  • Page 35: Tc-210

    X7504083609 35 © 4/2016 echo inc. Tc-210 storage fuel vapors are extremely flammable and may cause fire and/or explosion. Never test for ignition spark by grounding spark plug near cylinder plug hole, otherwise serious personal injury may result. Storage during operation the muffler or catalytic muf...

  • Page 36: Storage

    Storage tc-210 36 x7504083609 © 4/2016 echo inc. Do not store in enclosure where fuel fumes may accumulate or reach an open flame or spark. 2. Place the stop switch in the “off” position. 3. Remove accumulation of grease, oil, dirt and debris from exterior of unit. 4. Perform all periodic lubricatio...

  • Page 37: Tc-210

    X7504083609 37 © 4/2016 echo inc. Tc-210 specifications specifications model tc-210 length 1130 mm (44.48 in.) width 340 mm (13.36 in.) height 1010 mm (39.76 in.) weight (dry) w/tines 9.07 kg (20 lb.) engine type air cooled, two-stroke, single cylinder gasoline engine bore 32.2 mm (1.27 in.) stroke ...

  • Page 38: Notes

    Notes tc-210 38 x7504083609 © 4/2016 echo inc. Notes.

  • Page 39: Tc-210

    X7504083609 39 © 4/2016 echo inc. Tc-210 product registration product registration thank you for choosing echo power equipment please go to http://www.Echo-usa.Com/warranty/register-your-echo to register your new product on-line. It's fast and easy! Note: your information will never be sold or misus...

  • Page 40: Product Registration

    Product registration tc-210 40 x7504083609 © 4/2016 echo inc..

  • Page 41: Tc-210

    X7504083609 41 © 4/2016 echo inc. Tc-210 notes notes.

  • Page 42: Notes

    Notes tc-210 42 x7504083609 © 4/2016 echo inc..

  • Page 43: Tc-210

    X7504083609 43 © 4/2016 echo inc. Tc-210 notes.

  • Page 44: Echo, Incorporated

    Echo, incorporated 400 oakwood road lake zurich, il 60047 www.Echo-usa.Com e13912001001/e13912999999 e14712001001/e14712999999.