Echo Power Pruner PPFD-2400 Operator's Manual

Other manuals for Power Pruner PPFD-2400: Service Data, Operator's Manual, Operator's Manual

Summary of Power Pruner PPFD-2400

  • Page 1

    Power pruner tm hedge clipper attachment operator's manual model 99946400060 serial number 001001 & up models used on: ppt-230/231 ppt-260/261 ppt-2100 ppt-2400 ppfd-2400 warning danger read rules for safe operation and instructions carefully. Echo provides an operator's manual and a safety manual, ...

  • Page 2

    2 i ntroduction welcome to the echo family. This echo product was designed and manufactured to provide long life and on-the-job- dependability. Read and understand this manual and the safety manual you found in the same package. You will find both easy to use and full of helpful operating tips and s...

  • Page 3

    S haft h edge c lipper a ttachment o perator ' s m anual 3 s afety decals locate these safety decals on your power pruner tm unit. The complete unit illustration found in the "description" section of your power pruner tm operator's manual, will help you locate them. Make sure the decals are legible ...

  • Page 4

    4 international symbols s afety i nstructions personal condition and safety equipment physical condition your judgment and physical dexterity may not be good: • if you are tired or sick, • if you are taking medication, • if you have taken alcohol or drugs. Operate unit only if you are physically and...

  • Page 5

    S haft h edge c lipper a ttachment o perator ' s m anual 5 extended operation / extreme conditions vibration and cold it is believed that a condition called raynaud’s phenomenon, which affects the fingers of certain individuals may be brought about by exposure to vibration and cold. Exposure to vibr...

  • Page 6

    6 safe operation warning danger do not operate this product indoors or in inadequately ventilated areas. Engine exhaust contains poisonous emissions and can cause serious injury or death. Provide safety and operating instructions to all operators • provide all users of this equipment with the operat...

  • Page 7

    S haft h edge c lipper a ttachment o perator ' s m anual 7 d escription the echo product you have purchased has been factory pre-assembled for your convenience. After opening the carton, check for damage. Immediately notify your retailer or echo dealer of damaged or missing parts. Use the contents l...

  • Page 8

    8 tools required: screwdriver, cross-head screwdriver parts required: power pruner tm , hedge clipper attachment warning danger hedge clipper cutting blades are very sharp! Always wear gloves when handling assembly, otherwise serious personal injury may result. 1. Loosen the four (4) screws (a) and ...

  • Page 9

    S haft h edge c lipper a ttachment o perator ' s m anual 9 warning danger hedge clipper cutting blades are very sharp! Always wear gloves when handling assembly, otherwise serious personal injury may result. 3. Pull upper shaft tube (c) out of fiberglass lower shaft tube 127-152 mm (5-6 in.), then s...

  • Page 10

    10 adjust attachment position 1. Hard to reach areas can be trimmed by rotating the attachment in 90° increments. Loosen (do not remove) bolts (a). Rotate attachment in adapter (b) until desired blade attachment position is achieved. Align holes and tighten bolts (a). Adjusting cutting angle of blad...

  • Page 11

    S haft h edge c lipper a ttachment o perator ' s m anual 11 m aintenance your echo product is designed to provide many hours of trouble free service. Regular scheduled maintenance will help achieve that goal. If you are unsure or are not equipped with the necessary tools, you may want to take your u...

  • Page 12

    12 5. Check cutting blade tightness. Tighten blade bolts (a) until snug with 10 mm wrench. Loosen bolts 1/2 turn. Hold bolts (a) from turning and tighten locknuts (b) with other 10 mm wrench. Gear case tools required: grease gun with echo ® lube tm 14 oz. Cartridge p/n 91015 or lithium based grease....

  • Page 13

    S haft h edge c lipper a ttachment o perator ' s m anual 13 sharpening blades level 1. Tools required: flat file, small screwdriver. Parts required: gear box gasket, echo ® lube tm or lithium based grease. Note blades are very sharp. Wear gloves to protect hands. 1. Use screwdriver to separate upper...

  • Page 14

    14 notes.

  • Page 15

    S haft h edge c lipper a ttachment o perator ' s m anual 15 notes.

  • Page 16

    Echo, incorporated 400 o akwood r oad l ake z urich , il 60047 www.Echo-usa.Com s ervicing i nformation parts genuine echo parts and echo repower tm parts and assemblies for your echo products are available only from an authorized echo dealer. Service service of this product during the warranty peri...