Summary of Radiolink
Page 2: Radiolink
Radiolink tm television radio system – universal radio transmitter & receiver please read and follow the safety instructions before using the product content 1. Accessories picture 2. Features 3. Safety instructions and precautions 4. Setup and user instructions 5. Replacement parts 6. Technical spe...
Page 3: Accessories Picture:
Accessories picture: ① receiver ② charger ③ transmitter ④ scart \ adapter ⑤ ⑥ power adapter ⑦ headset ⑧ phono plugs ⑨ neckloop power adapter 1 ① ② ③ ⑤ ⑥ ⑦ ⑧ ⑨ ④.
Page 4: Features:
2 features: 1. Active noise reduction system for crystal clear sound 2. Operation distance up to 50 meters open air 3. Transmits through walls at home 4. Tone control (low/mid/high) can be set independently. Receiver has auto channel search tuning 6. Li-ion battery technology ensures a long operatin...
Page 5
Safety instructions and precautions: listening to uncomfortable sound levels for prolonged periods could adversely affect your hearing. If using a microphone, line input, headset or neck loop the plug must be fully inserted into the correct socket and the volume turned to the lowest level before tur...
Page 6: Setup and User Instructions:
4 setup and user instructions: 1.Place the radiolink tm transmitter near to the tv.(see fig 1) 2.Plug the 12v dc power adapter into a standard electrical wall socket, then connect the end of output lead into the transmitter dc12v socket. (see fig 2) 3.Plug the other 12v dc power adapter into a stand...
Page 7
4.Rotate the volume wheel on/off switch until the on/off led is off on the receiver and place the receiver on the charging base. When fully charged the charge led will turn to green. 5.If your tv has phono audio output sockets connect the 2 x phono plugs of the phono to 3.5mm lead to these sockets a...
Page 8
6 7.If the scart connection is not successful, connect the microphone. Simply plug the 3.5mm plug of the microphone cable into the mic socket on the transmitter (see fig 5) and then the microphone onto the tv speaker, using the velcro. 8.Remove the receiver from the base (or from the y patch lead) a...
Page 9
14.The red charge led on the receiver will light up red and when the batteries are fully charged again it will turn green. Note: the red led on the charging base will always be red when connected to the mains. This indicates only that it is connected to mains. 15.When the battery level is low, the o...
Page 10
Help and advice for connecting to tv with analogue audio output. When connecting a megaloop , echolink or radiolink to a tv. It is usually best not to use the scart sockets as this can result in picking up the wrong sound or sound that is out of sync with the picture. Step 1. When connecting to a tv...
Page 11: Audio Output
Help and advice for connecting to a tv. That has digital optical audio output many of the newer tv. Models no longer have analogue audio output, they have digital optical audio out or digital coaxial audio out. The picture below shows the type of socket to look for. To connect your equipment from th...
Page 12: Replacement Parts
10 replacement parts p/n qty description 465tx 1 radiolink tm transmitter (tx) 465rx 1 radiolink tm receiver (rx) 465base 1 charger base for radiolink rx 570-1000-01 2 12v dc power supply positive centre 575-1000-01 2 uk plug 490-1013-01 1 radiolink tm carton/instructions 306/b 1 phono phono combi l...
Page 13
11 t 1 system vhf/rf 2 carrier frequency 174.0mhz; 174.5mhz; 175.0mhz 3 modulation vhf 4 mode stereo 5 transmit power 7dbm(maximum) 6 s/n ratio 65db 7 channel separation 50db(minimum) 8 distortion 1.5% 9 frequency response 30 - 20,000hz 10 power supply of transmitter dc 12v positive centre min 200ma...
Page 16: Conformity
Conformity uk: waste electrical products and batteries should not be disposed of with household waste. Separate disposal facilities exist, for your nearest facility see www.Recycle-more.Co.Uk or hearing products international limited for full details www. Hear4you.Com hearing products international ...