Echo SRM-4605 Service Data

Other manuals for SRM-4605: Operator's Manual

Summary of SRM-4605

  • Page 1

    1 introduction we are constantly wor king on technical improvement of our products. For this reason, technical data, equipment and design are subject to change without notice. All specifications, illustrations and directions in this service data are based on the latest products infor mation availabl...

  • Page 2

    2 service information srm-3805 srm-4605 1 service information 1-1 specifications od: outer diameter. Id: inner diameter. *without shoulder harness and cutter head. **with standard cutter head. ***install and use u-shaped handle when operating with steel blade. Model srm-3805 (l) srm-3805 (u) srm-460...

  • Page 3

    1-2 technical data model srm-3805 srm-4605 engine idling speed rpm 2400 - 3000 operating speed rpm 6000 - 8000 clutch-in speed rpm 3300 - 3700 compression pressure, standard kgf/cm 2 (psi) 7.5 (107) 8.0 (114) ignition system spark plug gap mm(in) 0.6 - 0.7 (0.024 - 0.028) minimum secondary voltage a...

  • Page 4

    1-3 torque limits descriptions size kgf•cm in•lbf starter pawl carrier m 8 80 - 100 70 - 85 system pawl carrier nut m 8 160 - 200 140 - 175 starter center post m 5 * 25 - 35 22 - 30 starter case m 4 35 - 50 30 - 45 ignition magneto rotor (flywheel) m10 350 - 400 300 - 350 system ignition coil (cdi m...

  • Page 5

    Mm(in) description srm-3805 srm-4605 a cylinder bore when plating is worn and aluminum can be seen b piston outer diameter min. 37.90 (1.492) 41.90 (1.65) c piston pin bore max. 10.025 (0.3947) 10.025 (0.3947) d piston ring groove max. 1.3 (0.051) 1.3 (0.051) e piston ring side clearance 1st max. 0....

  • Page 6

    6 srm-3805 srm-4605 service information 1-6 special tools a 1.5 1.6 5 1.3 0.4 c a b 1 5 16 2 6 17 3 7 12: c=34 mm 13: c=31 mm 18 20 9 4 8 14 key part number description used for: 1 tachometer measuring engine speed to adjust carburetor 2 895610-79920 l-hex. Wrench(4 mm) removing and installing hex. ...

  • Page 7

    2 service hint 2-1 gear case construction 7 service information srm-3805 srm-4605 drive gear driven gear pto shaft nut adapter plate (l) gear case adapter plate (u) cover plate dust seal plate o-ring.