Echo SRM-510ES Service Manual

Other manuals for SRM-510ES: Operator's Manual

Summary of SRM-510ES

  • Page 1

    Srm-510es 10-52f-01 1 introduction w e are constantly working on technical im- provement of our products. For this reason, technical data, equipment and design are subject to change without notice. All speci- fications, illustrations and directions in this service data are based on the latest produc...

  • Page 2

    Service information srm-510es 2 1 service information 1-1 specifi cations model srm-510es (l) srm-510es (u) dimensions* length mm(in) 1860 (73.2) width mm(in) 355 (14.0) 655 (25.8) height mm(in) 324 (12.8) 460 (18.1) dry weight * kg(lb) 8.5 (18.7) 8.8 (19.3) engine type kioritz, air-cooled, two-stro...

  • Page 3

    Service information srm-510es 3 1-2 technical data model srm-510es (l) srm-510es (u) engine idling speed r/min 2,750 +/- 250 operating speed r/min 8,000 wide open throttle speed r/min 9,500 - 11,000* 1 11,000 - 11,700* 2 clutch engagement speed r/min 3,500 service limit speed † r/min 3,300 compressi...

  • Page 4

    Service information srm-510es 4 1-3 torque limits descriptions size kgf•cm n•m in•lbf starter starter pulley m 8 180 - 220 18 - 22 160 - 190 system starter case m 5* 35 - 50 3.5 - 5 30 - 45 ignition magneto rotor (flywheel) m 10 200 - 240 20 - 24 175 - 210 system ignition coil m 5 60 - 100 6 - 10 50...

  • Page 5

    Service information srm-510es 5 5k223 5k224 5k225 5k016 5k042 5k222 5k189 5k219 5k220 5k245 5k246 1-5 service limits a b c d e f g h k l m description mm (in) a cylinder bore when plating is worn and aluminum can be seen b piston outer diameter min. 43. 95 (1.730) c piston pin bore max. 10. 035 (0.3...

  • Page 6

    Service information srm-510es 6 a 1.5 1.65 1.3 0.4 a 0 0.4 50 0.8 1.2 1. Mpa 0 echo pet -304 oppama pet-9000 integrated ignition analyzer a b key part number description used for: 1 g310-000050 tachometer pet-304 measuring engine speed to adjust carburettor 2 895610-79920 l-hex wrench (4 mm) removin...

  • Page 7

    Service information srm-510es 7 2 carburettor adjustment procedure 2-1 general adjusting rules a. Before adjustment, check the following items. 1. The correct spark plug must be clean and properly gapped. 2. The air fi lter element must be clean and properly installed. 3. The muffl er exhaust port m...

  • Page 8

    Service information srm-510es 8 2-3 adjusting carburettor 1. Start and warm engine for 1 minute engine speed at wot. Note : if the engine doesn’t start, turn idle mixture needle anticlockwise in 1/2 turn increments. 2. Adjust idle mixture needle (d) to reach maxi- mum idle speed with 2.5 mm blade sc...