EchoStar DSB-880 2Ci User Manual - page 14
Section 2
EchoStar User Interface
Page 2 - 4
Digital Satellite Receivers - Fixed
© 2
0
03 E
c
hoS
tar
Inte
rnati
o
nal
C
o
rp
orat
io
n
A
ll ri
g
h
ts
re
s
e
rv
ed
English
2
D
ELETE
SAT
E
DIT
SAT
A
DD
TP
E
DIT
TP
E
DIT
PID
2.1.4. DISH INSTALLATION
■
1
To select the SAT that you want to delete. Note that all TV and
radio channels are deleted.
■
SAT
To show the current satellite you want to change the settings for.
■
LNB
To select the LNB that you want to use for the selected SAT.
■
Position
(DiSEqC1.2 only)
Shows the database number of the satellite.
■
Move dish
(DiSEqC1.2 only)
To move the dish and find the defined SAT.
■
Fine tune
(DiSEqC1.2 only)
To move the dish for best signal level and quality.
■
Re-align dish
(GoTo X only)
To compensate for a dish offset caused by ambient conditions.
■
SAT
To select the satellite you want to change the settings for.
■
Frequency
To set the required frequency (MHz).
■
Symbol rate
To set the required symbol rate (MSym/s).
■
LNB
To select the LNB that you want to use for the selected SAT.
■
Polarity
To select the required polarity (Horizontal/Vertical).
■
22kHz
To select the control signal (Auto, On, Off) for the switch.
■
Channel type
To search for All channels, only FTA or only Scrambled
channels.
■
Channel
To search for All channels, only TV, only Radio or only Data
channels.
■
Search channels
Search channels does a channel search on the defined TP.
■
SAT
(blue key)
To select the satellite you want to change the settings for.
■
Frequency
To view the current frequency (MHz).
■
Symbol rate
To view the current symbol rate (MSym/s).
■
Polarity
To view the current polarity (Horizontal/Vertical).
■
Delete
(yellow key)
To delete the selected transponder.
■
Edit PID
(green key)
To select the Edit PID sub-menu were you can set the required
settings (Frequency, Symbol rate, LNB and PIDs).
■
Confirm
(red key)
To confirm the new settings and return to the Edit TP menu.
■
SAT
To select the satellite you want to change settings for.
■
Frequency
To set the required frequency (MHz).
■
Symbol rate
To set the required symbol rate (MSym/s).
■
LNB
To select the LNB that you want to use for the selected SAT.
■
Polarity
To select the required polarity (Horizontal/Vertical).
■
Video PID
To set the required Video PID.
■
Audio PID
To set the required Audio PID.
■
PCR PID
To set the required PCR PID.
■
SAT
To select the satellite you want to check for the signal strength.
■
TP
To select the TP you want to check for the signal strength.
■
View
To list the channels that belong to the selected TP.