EchoStar T-333 MHP User Manual - page 7
“Snow” appears on your TV screen.
Your decoder is in standby. This is indicated by a red Standby
indicator on the front panel. Press the
button on your remote
control.
Some of the connections to your decoder may have worked loose.
Check that your decoder is connected to the power source and
correctly connected to your TV set.
The picture appears to be either
“squashed” (form side to side or top to
bottom) or cut off at the top and bottom of
the screen.
The Display Format in the Options menu has not been set to
correspond with your TV. Try a different setting.
There is no sound.
Check whether the Mute mode is active. If so, use the remote control
of your decoder and/or your TV set to cancel the Mute function.
Check whether the volume on your decoder or TV is sufficiently high.
Press the volume buttons on the remote control of your decoder or of
your TV set.
Check that your decoder is properly connected to your TV set or to
your sound system. Some of the connections to your decoder may
have worked loose.
There is no stereo sound on your HiFi
system.
Check whether the cables are connected correctly between your HiFi
system and right & left audio outputs at the back of your decoder.
Technical Specification
System:
Front-end: DVB-T
Input frequency range: VHF III: 177.5-227.5 MHz;
UHF IV/V: 474-858 MHz
Loop through frequency range: 51-858 MHz
Powered by STi5516 CPU
FLASH memory: 8 MB
RAM memory: 40 MB
Connectivity:
Antenna In
Antenna Out for analogue TV programs
TV SCART
3x RCA (video + stereo audio)
Optical S/PDIF digital audio output
V.92 Modem port
Smart Card reader
DC input from external power supply
Video:
MPEG-2 MP@ML
Video rate: 1.5 - 15 Mbit/s
Formats: 4:3, 16:9 with Pan & Scan, Letterbox
Graphics: 16 bit OSD, up to 720 x 576 pixels
Audio:
MPEG-1 audio layer I & II
Mono, Dual Mono, Stereo, Joint Stereo
AC-3 pass through S/PDIF
Conditional Access System:
Support for Conax and Irdeto
Software:
DVB MHP 1.0.2
Loader for Over The Air software upgrades
Teletext on VBI, DVB subtitles
Set of applications including among other things: Channel
Banner, Now/Next Navigator, Parental Control, Electronic
Program Guide
Accessories:
Remote control unit with batteries
External power supply unit: 12V DC, 1.5A
Set of cables
User documentation
Reliability & Compliance:
Fully DVB compliant
Quality according to EU norms, CE marking
MTBF: 50 000h
General Data:
Dimensions: 22w x 17d x 4.5h cm
One LED (On / Standby / RCU key pressed)
Operate mode consumption: max 8W
Standby mode consumption: max 4W
This specification is subject to improvement and change
without notice.
The product complies with the following
European Council Directives:
– 73/23/EEC (Low Voltage Directive),
– 89/336/EEC (EMC Directive).
DT 530 DIGITAL SET-TOP-BOX
7