ECKey EK6 Nstallation And Operation Manual - page 14
11.
Common ECKey Status Light Patterns
Note: The status lights on the EK6 can be controlled by an access control system via the purple wire. If
you are using this wiring option in your installation, be aware that the below table may not be accurate
regarding the status light colors.
ECKey Installation and Operation Guide
14
STATUS LIGHT
DESCRIPTION
Off
Not operating, check power supply
Red
Lock or closed and searching for phones (normal operating mode)
Red Flashing
Time allocated for closing
Green
Unlocked or open
Green Flashing
Time allocated for opening
Yellow
Passage/Administrative mode. ECKey is not searching for phones,
but can be connected over Bluetooth for administration
Blue
Single Flash to Off
ECKey requesting PIN from phone
Single Flash to Red
ECKey available to be discovered by phones for pairing
Single Flash to Yellow
ECKey requesting Manager PIN
Double Flashes
Phone has been paired and is now a Hidden device
Triple Flashes
ECKey available to be discovered for administration
Quadruple Flashes
Pending delete of all phones
Eight Flashes
Pending factory reset
Solid Momentarily
Sending Wiegand message (EK6 only). Solid blue for 3 seconds, or until
success/failure response is received from access control system
Solid for 3 Seconds
Pairing is successful
Solid for 5 Seconds
Confirmation of previous action
Purple
Factory upgrade was successful. Remove and reissue power to return to
normal operating state