Eckman EKECS21 Instruction manual - page 16
- 15 -
WARNING: When cutting free-hanging branches,the saw chain(2)and/or guide bar(1)may be pinched,or the branch
may fall.Either may cause the operator to lose control over the chainsaw.If the saw chain and /or guide bar becomes
pinched,stop the engine immediately,and remove the saw by lifting the branch.DO NOT try to pull the saw out,as this
may lead to damage or injury.
e) Remove pole saw from a cut with saw running at full speed. Stop pole saw by releasing trigger. Make sure chain has
stopped before setting pole saw down.
3) Brake device in the front of front handle
This saw is equipped with a mechanical brake device (see part 6 ) that will stop the chain when you pull it backward.
You must check the brake device before each usage
.
WARNING:
Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear CE approved safety goggles or safety glasses with side shields when operating power tools. Failure to do
so could result in objects being thrown into your eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of
attachments or accessories not recommended can result in serious personal injury.
5) STARTING AND STOPPING
Connect the multifunction chain saw plug to power supply.
To start the blade movement, push the lock-off button and then pull the trigger switch.
To stop blade movement, release the trigger switch.