Ecler eMOTUS5P User Manual - page 7
7
ST A RT U P
eMOTUS5P
To start up the system, turn on the MASTER (L) unit with the switch on the rear
panel and adjust the volume and equalizer to the required settings.
You may select the audio source (balanced or non-balanced input) by pressing the
rotating volume encoder.
eMOTUS5PB
To start up the system, turn on the MASTER (L) unit with the switch on the rear
panel and adjust the volume and equalizer to the required settings. Pressing the
rotating volume encoder, the unit will be muted.
You can select the audio source (balanced, non-balanced input or wireless
connection) by pressing the relevant button on the remote control: BAL, UNBAL or
BT.
Wireless connection
Press the BT key to select the wireless connection mode. For pairing the BT, the
eMOTUS5BT is displayed on other devices as the eMOTUS5 (password:”0000”). Once
paired with the emitting device, the eMOTUS5PB will act as a receiver/reproducer of
the audio emitted by the former.
N.B. To safeguard the system from any possible power surges in the electrical
supply, there is a network fuse in the MASTER unit, located in a screw mount fuse
holder in the rear panel. In the event of this blowing, disconnect the device, remove
it from the wall bracket, unscrew the fuse holder, take out the fuse and replace it
with another with identical characteristics. If the new fuse blows straight away,
consult our Technical Department.