Eclipse 091009 Assembly Instruction Manual - page 4
7
6
Assembly / Operating Instructions
Cot mode
HELPFUL HINTS
It is advisable that two people assemble the cot in the room in which it is to be used.
As small parts are involved in assembly, children should be kept clear of the assembly area.
Dispose of all packaging material immediately after the cot is assembled. Identify all parts and
components. Clear an area on the floor for assembly and place a sheet on the floor to ensure
the cot is not scratched during assembly.
Mattress base height
Use four cot assembly bolts provided to adjust mattress base height.
1. Mattress base in high position;
This is for use when your baby is young and cannot sit up
unaided.
2. Mattress base in low position;
This is the normal position for an active baby which can sit up
unaided.
PLEASE NOTE:
THE COT COMES WITH FILLING BOLTS ALREADY LOCATED IN THE LOWER HOLES OF
THE END PANELS. IF CHANGING THE MATTRESS BASE FROM THE UPPER TO THE LOWER
POSITION, YOU MUST SWAP OVER THE FILLING BOLTS. IT IS IMPORTANT THAT THE FILLING
BOLTS ARE REPLACED INTO THE OPEN HOLES. ENSURE THEY ARE SECURED TIGHTLY
WITH THE ALLEN KEY AND CHECK REGULARLY THAT THEY DO NOT LOOSEN.
Assembly / Operating Instructions
To attach side and end panels
1.
Place the side panel into the groove created by the end panels.
Please ensure the counter sunk on end panels are facing
outside.
2.
Using four 60mm bolts fix the side panels to the end panels as
shown.
3.
Repeat for the other side panel.
4.
Now that the side panels is in place. Tighten all bolts on the end
and side panels.