Eclipse 091009 Assembly Instruction Manual - page 6
11
10
Assembly / Operating Instructions
Assembling bottom feet
1.
Line up the four feet holes with the base frame holes. Ensure the
flat surface of the base frame is on the contact side of the foot
and the feet are facing outward.
2.
Turn the cot upside down. Secure the foot to the base frame
using four 25mm bolts.
3.
Repeat the steps above in order to assemble all four feet to the
base frame.
Warning: Do not over tighten the bolts. Over tightening bolts
may cause panels to crack.
The cot is now ready for use.
4.
Check and ensure that all four feet are properly tightened to the
base frame before continuing the assembly process.
Assembly / Operating Instructions
Cleaning
To ensure the long-lasting use of your cot, wipe down with a damp cloth and use a mild soap
solution if necessary. Do not use abrasive cleaners. Always store product in a clean dry place.
Maintenance
Always check parts regularly for tightness of bolts, nuts and other fasteners – tighten or
replace if required. To maintain the safety of your cot, seek prompt repairs for bent, torn, worn
or broken parts. Use only those parts and accessories approved by CNP Brands.
If the drop-side panel does not slide down smoothly, use a silicon based spray; ensuring it
penetrates the mechanism sufficiently.
If you have any difficulties in assembling the cot, please contact our Service Department.
In Australia, contact CNP Brands on 1300 667 137, in New Zealand contact Wainhouse
Distribution on 0800 567 5000.