Eclipse ECL-1000 User Manual - page 5
. Display
. Keypad Control
. Connect Cables
. Test
ECL-1000 Users’ Manual_08
09_ECL-1000 Users’ Manual
This instrument has an LCD display and keypad that are recessed into
the case.
Measurement
distance →
Tolerance →
V.O.P Value, list →
[Figure 5]
[Figure 6]
It shows when instrument has no connection or is connected to a cable
which out of range (too short, or too long). See
[figure 6]
.
① Backlight
Click Light Button , after turn on instrument. Backlight function
only activate at main display.
② Multi-Function
③ Navigation
These buttons are activated when show Up/Down list.
④ V.O.P
See “Velocity of Propagation” on page 10.
LIGHT
LIGHT
LIGHT
START
OK /
Condition
ESC
Click
Press & Hold
START
OK
Start the test
OK and Select the List
Return to the
Main screen
Return to
Previous menu
Caution
① The TDR operates only on cables that have two conductors.
② When testing cables, connect the instrument only to de-energized circuit.
③ Do not connect this instrument directly to live wire.
④ If this instrument detect above
± 250mV / 500kHz DC line,
automatically display warning
message.
⑤ When show this pop up, carefully
remove the cable from the
instrument.
⑥ Max. input voltage : DC 48V
[Figure 7]
Connect a cable to BNC Connector properly and click .
If you need to re-test or after change a cable, click . Then it refresh
and recalculate.
(If there is no change, please wait 5 sec without operation.)
START
OK /
START
OK /
V.O.P
V.O.P