Eclipse TD510ZMK2 Owner's Manual - Jap
− 12 −
JAP
ANESE
ENGLISH
GERMAN
FRENCH
IT
ALIAN
SP
ANISH
Installation
Installation
❶
Speaker
1
Insert the locking pin of the speaker into the locking ring
in the stand.
1
Determine the location for setting up the speaker stand.
2
Securely tighten the spikes on the base of the stand
before placing the stand on the floor.
Adjust the height.
Adjust the height of the spikes to provide a stable platform.
3
Ensure the stand is stable to obtain the best
performance.
2
Set the speaker onto the stand so that the three pins are
aligned with the grooves in the speaker.
❺
Spanner
- Adjusting the spikes -
- Installing the speaker -
Assemble this product on a flat, level surface. If you
assemble it on a sloping surface, the stand may fall
over.
Caution
If the stand is not adjusted correctly, it could fall
damaging the floor.
Caution
・ The speaker is heavy, and should be held with both
hands during installation.
・ Do not touch the cone while attaching the speaker to
the stand to ensure the driver is not damaged.
・ Be careful not to damage the base of the speaker
when fitting the speaker onto the stand.
Caution
Locking pin
Pins X3
Grooves X3
❷
Stand
❷
Stand
❺
Spanner
Locking ring
Tighten
Spikes
Spikes X5