Eclipse TD510ZMK2 Owner's Manual - Jap
− 13 −
JAP
ANESE
GERMAN
FRENCH
IT
ALIAN
SP
ANISH
ENGLISH
3
Tighten the locking ring to secure the speaker to the
stand.
1
Loosen the locking ring and adjust the speaker to the
desired angle.
2
Tighten the locking ring to secure the speaker.
- Adjusting the speaker angle -
- Connecting the speaker cable -
Securely tighten the locking ring.
Caution
1
Insert the bare ends of the speaker cable into the holes
in the speaker input terminals and secure them in place.
When connecting the speaker wires, insert the bare
ends of the speaker wires correctly so that they do not
touch neighboring terminals, otherwise it may cause
short-circuits.
Caution
Be careful not to let the speaker stand fall over while
adjusting the angle.
Caution
Speaker input terminals
Speaker cable
❷
Stand
❶
Speaker
❶
Speaker
+15°
-10°
Tighten
Loosen
Speaker cable
(For less than φ7 mm dia.)
Tighten
Before the locking ring is tightened, the angle of
the speaker can be adjusted. For details, refer to
“Adjusting the speaker angle” below.
Tip
When connecting the speaker cable, if the speaker
cable is routed through the groove in the stand, it will
improve the outer appearance. (For less than φ7 mm
dia.)
Tip
The angle of the speaker can be adjusted within the
range of +15° to -10°.
Tip
Locking ring
Locking ring