1. DL manuals
  2. Eco-Aire
  3. Heater
  4. 2400
  5. Owner's Operation And Instruction Manual

Eco-Aire 2400 Owner's Operation And Instruction Manual

Manual is about: WINDOW PELLET HEATER

Summary of 2400

  • Page 1

    Ussc 1 owner’s operation and instruction manual safety notice: if this heater is not properly installed, a house fire may result. For your safety, follow the installation in- structions. Contact your local building or fire officials about obtaining a permit, restrictions and installation requirement...

  • Page 2

    2 ussc important: read this entire manual before installing and operating this product. Failure to do so may result in property damage, bodily injury, or even death. Proper installation of this heater is crucial for safe and efficient operation. Never use make-shift compromises during the installati...

  • Page 3

    Ussc 3 " cut here " cut here warranty information card name__________________________________________ telephone #: (_____)_____________ city____________________________________________ state_______ zip_________________ email address __________________________________________________________________ ...

  • Page 4

    4 ussc " cut here " cut here Ê É fold here fold here united states stove company p.O. Box 151 south pittsburg, tn 37380 fold here place stamp here.

  • Page 5

    Ussc 5 fuel considerations your pellet heaterisdesigned to burn certified premium hardwood pellets that comply with association of pellet fuel industries standards. Pellets that are soft, contain excessive amounts of loose sawdust, have been, or are wet, will result in reduced performance. Failure t...

  • Page 6

    6 ussc read this entire manual before you install and use your pelletheater. Failure to follow instructions may result in property damage, bodily injury, or even death! Before installing your heater, you must perform an initial burn in an outside environment. Follow the start- up procedure in the op...

  • Page 7

    Ussc 7 floor protection this heater must have a non-combustible floor protector (ember protection) installed beneath it if the floor is of combustible material. If a floor pad is used, it should be ul listed or equal. The floor pad or non-combustible surface should be large enough to extend a minimu...

  • Page 8

    8 ussc when installing your heater in a window • select a window of adequate size and with the ap- propriate clearances needed for a safe installation. The mounting hardware supplied is designed for the appliance to be installed in the approximate center of the window. You will need to provide the a...

  • Page 9

    Ussc 9 window sill mount- ing brackets window installation installing the filler panels • begin by assembling the left and right side filler panels together. Slide part a into part b; notice the range of adjustment. If the openings on each side of the heater exceeds this range, you will have to fill...

  • Page 10

    10 ussc when installing your heater in an exterior wall • select a wall to the exterior of the building. This wall should have the required clearance to combustibles inside and out mentioned earlier in this manual. Make certain that electrical wires, conduit, water or gas pipes do not pass through t...