Eco-Aire 2400 Owner's Operation And Instruction Manual - page 8
8
Ussc
When Installing your heater in a window
• Select a window of adequate size and with the ap-
propriate clearances needed for a safe installation.
The mounting hardware supplied is designed for the
appliance to be installed in the approximate center
of the window. You will need to provide the attach-
ing hardware, (i.e. screws, wall anchors, etc.) of which
should be suitable for mounting to the outside surface
of your home or structure. You may choose to utilize
the supplied mounting system or a configuration of your
own.
However, U.S. Stove shall not be liable for faulty
mounting configurations.
• Depending on your application, a solid resting surface
will need to be established on the window sill. If your
selected window’s bottom flange rises above the sill, a
board will need to be placed and should be level with
or just rise above that flange. Use the illustration to the
right for reference.
• The supplied support brackets will need to be mounted
before inserting the heater into the window. These
pieces will mount to the outside of the home or structure.
• Assemble the two Knee Braces to the Retention Bracket
using a washer
(d) and nut (e) for each side. Tighten the
nuts then back them off to allow the bracket to slide
back and forth along the knee braces.
• Using a carpenter’s level or a straight edge, determine
the height of the retention bracket in relation to the
resting surface of the heater. Once you’ve determined
that mark, locate the mounting assembly 1/4” lower to
allow for precipitation runoff.
• Attach the Knee Braces to the home or structure using
the hardware that you have determined suitable for
your application.
• Once you’ve stabilized the Knee Braces, you’re ready
to insert the heater into the window/opening. Slide the
heater thru the window or opening. Insert item “
a” in the
center hole of the bottom but don’t tighten fully. Allow
item “
a” to engage the SLOT in the retention bracket
as shown in the illustration to the right. Slide the heater
into the window opening until it stops. The heater should
either stop on the window sash at the back of the hop-
per lid or on the window sill when it reaches the fan
enclosure, whichever comes first.
• Align the holes in the retention bracket and heater bot-
tom. Insert a washer
(b) and bolt (c), and tighten.
• Tighten the two nuts
(e) on the knee braces.
• Using the window sill brackets, mount them to the side
of the heater, using the existing cabinet screws, then to
the top of the window sill with the screws provided. See
illustration on the following page.
• Lower the sash onto the top of the heater and proceed
to install the window insulation/filler panels.
Window Installation
SLOT
a
b
c
d
e
Retention
Bracket
Knee
Braces