Eco-Aire 2400 Owner's Operation And Instruction Manual - page 3
Ussc
5
4
Ussc
FUEL CONSIDERATIONS
Your Pellet heater is designed to burn certified Premium
Hardwood pellets that comply with Association of Pellet Fuel
Industries standards. Pellets that are soft, contain excessive
amounts of loose sawdust, have been, or are wet, will result in
reduced performance. Failure to use proper fuel can affect the
longevity of the appliance. Smaller pellets could affect feed rates.
Store your pellets in a dry area and well away from the heater.
SAFETY AND COMPLIANCE
24
⅞
[632]
12
⅜
[314]
12
½
[318]
13
¾
[349]
5
½
[140]
4 [102]
21
⅜
[543]
22
⅞
[581]
22
½
[572]
Heating Specifications
Height
21⅜ in. [543mm]
Width
22½ in. [572mm]
Depth
27⅛ in. [689mm]
Weight
126½ lbs. [57.5kg]
Dimensions
1
BTU output will vary depending on the quality of fuel. Use PFI listed
fuels for the best results.
2
Heating capacity will vary depending on floor plan layout of your home,
degree of insulation, and the outside temperature.
3
Pellet size may effect the actual rate of fuel feed and burn times. Fuel
feed rates may vary by as much as 20%. Use PFI listed fuel for best results.
Electrical Rating
110-120 volts, 60 HZ, 3.0 Amps
Watts (operational)
175 (approx.)
Watts (igniter running)
425 (approx.)
Electrical Specifications
Minimum Cut-out / Window Opening
inches [milimeters]
14” x 22¾”
[356 x 578]
Window / Cut-Out Dimensions
"
CUT
HERE
"
CUT
HERE
Ê
É
Fold Here
Fold Here
United States Stove Company
P.O. Box 151
South Pittsburg, TN 37380
Fold Here
PLACE
STAMP
HERE
Specifications
Heat Output
1
16,400 BTU/hr.
Heating Capacity
2
500 - 1,000 sq. ft.
Fuel Burn Rate
3
¾ - 2½ lbs./hr.
Burn Time (lowest setting)
approx. 35-40 hrs.
Hopper Capacity
approx. 30 lbs.
Pellet Fuel Institute (PFI) Premium Standards
Min. Density
40 lbs. per cubic ft.
Size
¼
” to
5
/
16
” diameter, length no greater than 1
½
”
Heat Output
8,200 BTU/lb
Moisture Content
8% by weight or less
Ash Content
1% by weight
Salt Content
300 parts per million or less
Your Pellet heater has been safety tested and listed to ASTM E 1509-04 and ULC S627-00, by Intertek Testing Services in Portland,
Oregon, USA.