Eco F790 Instruction Manual - page 8
Page 8
Installation
3
x
Place the product on a flat surface to avoid
vibration.
x
Place the product at least 30 cm away
from heaters, stoves and similar sources
of heat and at least 5 cm away from
electric ovens.
x
Do not expose the product to direct
sunlight or keep in damp environments.
x
The product requires adequate air
circulation to function efficiently. If the
product will be placed in an alcove,
remember to leave at least 5 cm distance
between the product and the ceiling and
the walls.
x
Do not install the product in environments
with temperatures below -5°C.
Contact the Authorized Service for the
product's installation. To ready the product
for installation, see the information in the
user guide and make sure the electric and
water utilities are as required. If not, call an
electrician and plumber to arrange the
utilities as necessary.
WARNING: The manufacturer
assumes no responsibility for
any damage caused by the
work carried out by
unauthorized persons.
WARNING: The product’s
power cable must be unplugged
during installation. Failure to do
so may result in death or
serious injuries!
WARNING: If the door span is
too narrow for the product to
pass through, remove the door
and turn the product sideways;
if this does not work, contact the
authorized service.
Attaching the plastic wedges
Use the plastic wedges provided with the
product to provide sufficient space for air
circulation between the product and the wall.
1. To attach the wedges, remove the screws
on the product and use the screws provided
with the wedges.
2. Attach the 2 plastic wedges on the
ventilation cover shown as in the figure.
Installation location