Eco F790 Instruction Manual - page 9
Page 9
Adjusting the feet
x
If the product is not in a balanced position,
adjust the front adjustable feet by rotating
right or left.
WARNING: Do not use
extension or multi sockets in the
power connection.
WARNING: Damaged power
cable must be replaced by
authorized service.
When placing two coolers in an
adjacent position, leave at least
4 cm distance between the two
units.
Water connection
(Optional)
Installation
Power connection
x
Our firm will not assume responsibility for
any damages due to usage without
earthing and power connection in
compliance with national regulations.
x
The power cable plug must be easily
accessible after installation.
x
Connect the refrigerator to an earthed
socket with 220-240V/50 Hz voltage. The
plug must comprise a 10-16A fuse.
x
Do not use a multi-group plug with or
without an extension cable between the
wall socket and the refrigerator.
WARNING: Unplug the product
and the water pump (if available)
during connection.
x
The product’s water mains, filter and
carboy connections must be done by
authorized service. The product can be
connected to a carboy or directly to the
water mains, depending on the model. To
establish the connection, the water hose
must first be connected to the product.
x
Check to see the following parts are
supplied with your product model:
1. Connector (1 piece): Used to attach the
water hose to the rear of the product.
2. Hose clip (3 pieces): Used to fix the water
hose on the wall.
3. Water hose (1 piece, 5 meters, diameter
1/4 inches): Used for the water connection.
4. Faucet adapter (1 piece): Comprises of a
porous filter, used for connection to the
cold water mains.
5. Water filter (1 piece *Optional): Used to
connect the mains water to the product.
Water filter is not required if a carboy
connection is available.