- DL manuals
- Eco-ideal
- Stove
- eco 4
- Installation And Operating Instructions Manual
Eco-ideal eco 4 Installation And Operating Instructions Manual
Summary of eco 4
Page 1
Jineco04 revd 28/10/11 eco 4 eco 4 eco 4 eco 4 clean burn stove installation and operating instructions.
Page 2
Jineco04 revd 28/10/11 eco 4 technical specification appliance mass 88 kg total efficiency 73.0% nominal heat output 4.9 kw mean co emission (@13% o 2 ) 0.16 % mean flue gas temperature 288 °c flue gas mass flow 6.5 g/s this appliance is not for use in shared flue this appliance is suitable for inte...
Page 3
Jineco04 revd 28/10/11 general guidance it is important that your stove is correctly installed as hunter stoves cannot accept responsibility for any fault arising through incorrect use or installation. These instructions cover the basic principles to ensure satisfactory installation of the stove, al...
Page 4
Jineco04 revd 28/10/11 fireguards always use a fireguard in the presence of children, the elderly or the infirm. The fireguard should be manufactured in accordance with bs8423 – fireguards for use with solid fuel appliances. Do not over-fire it is possible to fire the stove beyond its design capacit...
Page 5
Jineco04 revd 28/10/11 assembly instructions flue collar wind the eight m6 studs supplied into the fixing holes in the flue collar and blanking plate until finger tight. Place the gasket in position on the top plate of the stove and lower the flue collar or blanking plate (as required) on to the sto...
Page 6
Jineco04 revd 28/10/11 slide the base of the side brick towards the centre of the stove and remove. Rear brick pull the top edge of the rear brick forward and lift the brick out of the stove. Baffle / throat plate lift the baffle and slide to the left. When the right side of the baffle clears the ba...
Page 7
Jineco04 revd 28/10/11 installation instructions chimney the chimney height and the position of the chimney terminal should conform to building regulations. Check that the chimney is in good condition, dry, free from cracks and obstructions. The diameter of the flue should not be less than 127mm and...
Page 8
Jineco04 revd 28/10/11 minimum draught – 1.2mm water gauge maximum draught – 2.5mm water gauge air supply the room or space containing this appliance should have purpose provided ventilation (where necessary) in accordance with building regulations. Due consideration should be given to requirements ...
Page 9
Jineco04 revd 28/10/11 stove up the chimney and emitted safely to atmosphere. Do not run the stove at full output for at least 24 hours. On completion of the installation and commissioning, ensure that the operating instructions and operating tools for the stove are left with the customer. Advise th...
Page 10
Jineco04 revd 28/10/11 operating instructions this appliance is not suitable for use in a shared flue operation with the door open can cause excess smoke. This appliance must not be operated with the door open aerosol sprays do not use an aerosol spray on or near the stove when it is alight. Air con...
Page 11
Jineco04 revd 28/10/11 to burn wood, push the operating tool up and away from you. When left in this position, air is restricted through the bed of the fire providing a solid base to build up a bed of ash. Surplus ash can be removed either by gentle riddling or with a shovel. It might prove benefici...
Page 12
Jineco04 revd 28/10/11 reduced combustion in order to shut down the stove, close the primary control, then close the secondary air slider by moving the handle all the way to the left. If the controls are left in this position, the fire will be starved of air and will die down. If you want to revive ...
Page 13
Jineco04 revd 28/10/11 no liquid fuels should be burnt on this appliance. Should any difficulties arise over fuel quality or suitability, consult your local approved coal merchant or: hetas ltd – telephone 01242 673257 – www.Hetas.Co.Uk solid fuel association – telephone 0800 600 000 – www.Solidfuel...
Page 14
Jineco04 revd 28/10/11 chimney and flue ways it is important that the chimney, flue ways and any connecting flue pipe are swept regularly. This means at least once a year for smokeless fuels and at least twice a year for wood and other fuels. The baffle will need to be removed from its supports in o...
Page 15
Jineco04 revd 28/10/11 spares information door spares.
Page 16
Jineco04 revd 28/10/11 body assembly spares.