Eco-Smart ATI-HPE-PD Owner's Manual - Warning!
- 4 -
WARNING!
DO NOT DEPEND ON THE ON/OFF BUTTON OR POWER SWITCH AS THE
SOLE MEANS OF DISCONNECTING POWER WHEN SERVICING OR MOVING
THE APPLIANCE. ALWAYS UNPLUG THE POWER CORD.
1. When the air purifier is initially plugged in, the buzzer will come on a “beep” voice
and Power Indicator will remain lit indicating that there is power to the unit.
2. Turn the air purifier on by pressing On/Off Button ( ) and pressing On/Off
Button ( ) again will turn the air purifier off. (Figure 1)
3. When initially turned on, the LED Displayer will display the current room
temperature in ° Fahrenheit. Press Mode Button ( ) down for two seconds to
change the display to ° Celsius. Press Mode Button ( ) down for two seconds
again to change the display back to ° Fahrenheit.
NOTE: Press Mode Button ( ) on the remote control can not achieve the
exchange of temperature.
4. Upon turning the air purifier on, the unit will be in PU:HI ( Purify : High )mode.
5. Pressing Mode Button ( ) at this point will set the air purifier into PU:LO
( Purify : Low )mode.
6. Pressing Mode Button ( ) again will set the air purifier into PU+WA ( Purify +
Warm )(900 Wattage)mode.
7. Pressing Mode Button ( ) again will set the air purifier into PU+HO ( Purify +
Hot )(1500 Wattage) mode.
8. Pressing Mode Button ( ) once more will set the air purifier back to PU:HI
( Purify : High )mode.
9. To turn the air purifier off, press the On/Off Button ( ).
TIMER FUNCTION: This function will work in any mode. The timer function allows
you to set the length of operation from 1 hour (1H) to 8 hours (8H). Press Timer
Button ( ) to set your desired operation time. Once the timer has been set, the
timer indicator will lit and the timer will count down the hours, until the air purifier
turns itself off. Pressing Timer Button ( ) once more after the timer indicator
reflects 8 hours (8H) will reset the air purifier to continuous running.