ECO Spot LED C25 User Manual - page 2
ECO Spot LED C25 User Manual
Page 2
Copyright © 2017 Globus New Media LLC
Handling Instructions
Projection Lenses
The projector accommodates interchangeable projection lenses to allow optimizing the
projection size and resulting brightness at varying distances. The narrower the lens, the
smaller and brighter the image will be at a given distance.
Focusing
Gobo Rotator
The gobo rotator can be turned on/off with the push-button switch on the back plate.
There are no controls for rotating speed or direction.
Dimming
If equipped, the projection brightness can be adjusted with the manual dial on the front
plate.
Yoke
•
Before the initial start-up, please unpack and carefully check for damage caused
during transportation.
•
Place your fixture at a suitable place with good air flow.
•
Make sure there are no flammable materials close to the lamp.
•
When suspending the fixture above ground level, verify that the structure can hold
at least 10 times the weight of all installed devices.
•
Verify that all external covers and rigging hardware are securely fastened and use
an approved means of secondary attachment such as a safety cable.
•
Power up the projector by pressing the power switch in the back.
•
Focus the projection by twisting the lens in and out until the image is well focused.
When used for the first time, the lens will often need to be twisted outwards many
rotations to reach the focusing point.
•
Turn on the gobo rotator with the push-button in the back and switch it off when
the gobo projects in the desired position.
•
Re-adjust the focus if necessary.
•
The projector is mainly designed for wall and ceiling mounting but in many cases,
it can also be placed on a table or shelf.
•
The yoke allows projector movement in three directions:
Up/down and sideways tilt with the two Allen screws, and rotation by loosening
the large sleeve at the yoke base.